Channels - Philips 32PFL35 8G Series User Manual

Channels

Automatic installation
When the TV was switched on for the first
time, a full installation of channels was
performed.
To change your language, country, and
reinstall all available TV channels, you can run
this full installation again.
Start installation
Note: If you are prompted to enter a code,
enter '8888'.
1. Press .
2. Select [Setup] > [Search for channels] >
[Reinstall channels], then press OK.
3. Select your country, then press OK.
4. Select your network, then press OK:
•
[Antenna]: Access free-to-air antenna
transmissions.
•
[Cable]: Access cable transmissions.
5. Follow the onscreen instructions to select
other options, if any.
The start menu for channel search is
displayed.
6. Select [Start], then press OK.
7. Once the channel search is complete,
select [Finish], then press OK.
Tip: Press LIST to see the channel list.
Note: When digital TV channels are found,
the list of installed channels may display
empty channel numbers. You can rename
these channels.
Install digital channels
If you know the channel frequency of the
channels you want to install, you can search
and store digital channels one by one. For
best results, contact the service provider.
1. Press .
2. Select [Setup] > [Channel settings] >
[Channel installation].
3. Select [Digital: Reception test] > [Search
channel], then press OK.
4. Press the Numeric buttons to enter the
channel frequency.
5. Select [Search], then press OK.
6. When the channel is found, select [Store],
then press OK.
Update channel list
1. Press .
2. Select [Setup] > [Search for channels] >
[Update channels], then press OK.
3. Follow the onscreen instructions to
update the channels.
Copy channels
ATTENTION: This feature is intended for
dealers and service personnel.
You can copy channel lists from one Philips
TV to another through a USB storage
device. You do not need to search for
channels or install them again on the second
TV. The channel list file is small enough to fit
on any USB storage device.
What you need
Two Philips TVs that have these properties:
•
The same country setting
•
The same year range
•
The same hardware type, as indicated
by the sticker on the back of the TV.
For example: L12M3.1L LA
•
Compatible software versions
Note: If you are prompted to enter a code,
enter '8888'.
Step 1: Check the country setting
1. Switch on the first TV (with the channels
that you want to copy to the second TV).
2. Press .
3. Select [Setup] > [Search for channels] >
[Reinstall channels], then press OK.
The country menu is displayed.
4. Make a note of the current setting.
5. Press .
6. Press [Cancel] to exit.
Step 2: Copy channel list to USB
1. Connect a USB storage device to the first
TV (with the channels installed on it).
2. Press .
3. Select [Setup] > [Channel settings].
4. Select [Channel installation] > [Copy
channel list] > [Copy to USB], then press
OK.
The channel list is copied to the USB storage
device.
5. Disconnect the USB storage device.
EN 35