Getting Started; Projector Source And Control Connections; Making Connections; Connector Specifications - Barco F70-W8 User Manual

5. GETTING STARTED

About this chapter
This chapter describes how to set up and optimize your projector setup when the physical installation process is complete.
Overview
•

Projector source and control connections

• Power up the projector
• Power down the projector
• Power modes
• Customize projector settings
• User interface
5.1 Projector source and control connections
Overview
•

Making connections

• Connector specifications
• Control interfaces
5.1.1 Making connections
The source switching time varies from 0.5 to 5 seconds.
Source signal connectivity
The connector panel at the back of the projector is used for all source connections.
Source signal connectivity on the projector is:
• 2x Dual Link DVI-I (DVI-D functionality)
• 2x DisplayPort 1.2
• 1x HDMI 2.0
• 1x HDBaseT w/Ethernet
• 1x 3G SDI
5.1.2 Connector specifications
Overview
•

DVI-I

• Display Port 1.2
• HDMI 2.0
• 3G-SDI
• HDBase T
5.1.2.1 DVI-I
Specifications
Parameter
Connector
Signal characteristics
Max. cable length
601–426 F70 SERIES 16/06/2017
Value
DVI-I female digital RGB
DVI 1.0, Digital, TMDS
25 m (24 AWG)
5. Getting started
41