Redialling; Answering A Call - Sharp GX293 Manual

Redialling

You can redial numbers in the call log. Select from specific
categories or "All Calls". Specific category contains up to 10
numbers and the "All Calls" list contains up to 30.
Press D during stand-by.
1.
2.
Select the category from "All Calls", "Dialled Nos.",
"Missed Calls" or "Received Calls".
To switch logs, press c or d.
3.
Select the phone number you wish to call.
4. Press D to redial the call.
Automatic Redialling
This setting allows you to automatically redial the number if the
first attempt was unsuccessful because the called party was
busy.
If you wish to stop redialling, press F or [End].
To Set the Auto Redial Function
→
"Settings" "Call Settings"
1.
Select "On" or "Off".
Note
• When you receive an incoming call, the Auto Redial function
is interrupted.
• Automatic redialling is not available for fax and data calls.
→
"Auto Redial"

Answering a Call

When an incoming call is detected, the phone rings.
1. Press D,
or [Answer] to answer the call.
Or press any key except F and [Busy] when the "Any Key
Answer" function is enabled. Set the Any Key Answer
function in the profile of each mode (p. 96).
Tip
• When the handsfree is connected to the phone, you can
answer calls by pressing the Answer button.
• If you have subscribed to the Calling Line Identification (CLI)
service and the caller's network sends the number, the
caller's number is displayed on the screen. If the caller's
name and number are stored in the Phonebook, the caller's
name and phone number are displayed on the screen.
• If the number is a restricted number, the display shows
"Withheld".
• When receiving a call from the person whose picture is
registered in the Phonebook, receiving display and the
picture are displayed alternately.
Call Functions 21