Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Zanussi ZGNN955X
Summary of Contents for Zanussi ZGNN955X
- Page 1 User Manual GETTING STARTED? EASY. ZGNN955X EN User Manual...
- Page 2 VISIT OUR WEBSITE FOR: Get usage advice, brochures, trouble shoot- er, service and repair information: www.zanussi.com/support SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damage that are the result of incorrect installation or usage.
- Page 3 WARNING: Unattended cooking on a hob with fat or oil can be • dangerous and may result in fire. NEVER try to extinguish a fire with water, but switch off the • appliance and then cover flame e.g. with a lid or a fire blanket. CAUTION: The appliance must not be supplied through an •...
-
Page 4: Gas Connec-R 1/2" Tion
INSTALLATION • Make sure the appliance is installed correctly. Loose and incorrect electricity mains cable or WARNING! Only a qualified person plug (if applicable) can make the terminal must install this appliance. become too hot. • Use the correct electricity mains cable. •... - Page 5 • Make sure the flame does not go out when you quickly turn the knob from the maximum to the WARNING! Risk of injury, burns and minimum position. electric shock. • Use only the accessories supplied with the appliance. • Remove all the packaging, labelling and •...
- Page 6 • Disconnect the appliance from the mains • Flat the external gas pipes. supply. • Cut off the mains electrical cable close to the appliance and dispose of it. INSTALLATION Location WARNING! Refer to Safety chapters. The hob may be located in a kitchen, a kitchen/ diner or bed sitting room (with a volume greater than 20 m³), but not in a bathroom or shower room.
-
Page 7: Burner
The connection should be suitable for connecting to R 1/2 (1/2 BSP male thread). When the final connection has been made, it is essential that a thorough leak test is carried out on the hob and installation. Make sure that the main connection pipe does not exert any strain on the hob. - Page 8 The hob has a terminal block which is marked as follows: • L — Live terminal • N — Neutral terminal • or E — Earth terminal Before carrying out the connection, make sure: 1. The limiter valve and the electrical system can take the appliance load (see the rating plate) 2.
- Page 9 REPLACEMENT OF THE CONNECTION ASSEMBLY CABLE The replacement of electric cable must be carried out exclusively by the service force centre or by personnel with similar competencies, in accordance with the current regulations. To replace the connection cable use only H03V2V2-F T90 or equivalent type.
- Page 10 If a furniture unit is installed at a distance of 400 mm above the hob, there must be a minimum safety distance of 50 mm to the left or right from the edge of the hob. CAUTION! Install the appliance only on a worktop with flat surface.
-
Page 11: Multi Crown
PRODUCT DESCRIPTION COOKING SURFACE LAYOUT Semi-rapid burner Multi Crown burner Auxiliary burner Rapid burner Control knobs CONTROL KNOB Symbol Description Symbol Description minimum gas supply no gas supply / off position ignition position / maximum gas supply DAILY USE WARNING! Refer to Safety chapters. BURNER OVERVIEW A. - Page 12 IGNITION OF THE BURNER If the burner accidentally goes out, Always light the burner before you put turn the control knob to the off position on the cookware. and try to light the burner again after minimum 1 minute. WARNING! Be very careful when you The spark generator can start use open fire in the kitchen automatically when you switch on the...
-
Page 13: Auxiliary
CAUTION! Make sure that pot Diameter of cook- handles are not above the front edge Burner ware (mm) of the cooktop. CAUTION! Make sure that the pots Multi Crown 180 - 260 are placed centrally on the burner in order to get the maximum stability and Rapid 180 - 260 a lower gas consumption. - Page 14 dirt can cause damage to the hob. Take care to components well clean to prevent difficult lighting avoid burns. and check that the burner crown holes are not • Remove when the hob is sufficiently cool: obstructed. limescale rings, water rings, fat stains, shiny metallic discoloration.
-
Page 15: Rapid
LABELS SUPPLIED WITH THE ACCESSORIES Stick the adhesive labels as indicated below: MOD. MOD. MOD. TYPE PROD.NO. IP20 PROD.NO. PROD.NO. SER.NO. 0049 SER.NO SER.NO 03 IT DATA DATA MADE IN ITALY A. Stick it on Guarantee Card and send this part C. -
Page 16: Table Of Contents
BURNER POWER kW POWER kW MARK G30 28-30 mbar G31 37 mbar Multi Crown 3,65 Rapid 0,95 Semi-rapid Auxiliary 0,33 ENERGY EFFICIENCY PRODUCT INFORMATION ACCORDING TO EU 66/2014 Model identification ZGNN955X Type of hob Built-in hob Number of gas burners... - Page 17 Left front - Semi-rapid 55.3% Left rear - Semi-rapid 57.4% Energy efficiency per gas burner Middle - Multi Crown 54.3% (EE gas burner) Right front - Rapid 58.5% Right rear - Auxiliary not applicable Energy efficiency for the gas hob 56.4% (EE gas hob) EN 30-2-1: Domestic cooking appliances burning gas - Part 2-1 : Rational use of energy - General...
- Page 20 WWW.ZANUSSI.COM/SHOP...