Lcd Features; Setup; Atomic Time - La Crosse Technology C85845V2 Instruction Manual

LCD Features

Alerts (HI-LO-OFF)
1
1
Temperature Trend
2
Indoor Temperature
3
3
Low Battery
4
Indoor Humidity
5
Humidity Trend
6
Comfort Chart
7
5
Forecast Trend
1
Forecast Symbols
2
AM/PM
3

Atomic Time

4
Alarm/Snooze
5
Weekday
6
Month/Date
7
3
Atomic Reception
8
5
6
Alerts (HI-LO-OFF)
1
Temperature Trend 1
2
Outdoor Temperature
3
3
Low Battery
4
Sensor Strength
5
Outdoor Humidity
6
Humidity Trend
7
6
8 Comfort Chart
Buttons (on top)
ALERTS ALARM TEMP SNOOZE/BACKLIGHT
Page | 1 www.lacrossetechnology.com/support
2
4
6
7
1
2
4
7 8
2
4
5
7
8
SET
C85845v2

Setup

1. Insert 2-AA batteries (not included) into the TX141TH-Bv3 sensor.
Observe correct polarity.
2. Insert 5.0 volt AC cord into the outlet, then into the weather
station.
3. (Optional): insert 3-AAA batteries (not included) into the weather
station. Observe correct polarity.
4. Set language, time, date etc.
5. After 5 minutes, place sensor outside in a shaded location.
AAA
AAA
AAA
Atomic Time
• The station will search for the atomic signal at UTC 7:00, 8:00,
9:00, 10:00, and 11:00.
• If there is no WWVB reception, the station will search for the atomic
time signal every 2 hours until the WWVB time is received.
• The atomic time signal icon will flash while searching. The tower
icon will be solid when it has connected.
• After reception, this station will only search for the atomic signal
after midnight.
• From normal time display, press and release the SET button to
search for the WWVB time signal.
• Please be sure you have selected your time zone from the list in the
Settings menu. When the Atomic time signal is received, the station
will set to the time zone selected. Default is Eastern Time.
• For information about WWVB visit:
www.nist.gov/pml/div688/grp40/wwvb.cfm
C85845v2 www.lacrossetechnology.com/support Page | 2