Starting The "Water Filter"Or "Frost Protection" Programme - Siemens EQ9+ S400 TI923 Series Instruction Manual

Factory settings
Demo mode
Child-proof lock
--------
Starting the "Water filter"or
"frost protection" programme
Briefly press the $/± button.
1.
The rotary selector can be used to
2.
select the "Water filter" or "frost
protection" programme. The current
setting is marked on the display.
Note: The rotary selector can also be
used to select a service programme.
~ "Service programmes" on page 27
Water filter
A water filter lessens limescale deposits
and reduces impurities in the water. The
appliance also does not need to be
descaled so often. Water filters are
available from retailers or from
customer service. ~ "Accessories"
on page 11
If a water filter is inserted, the appliance
will show when it needs to be changed.
The display shows the relevant prompt.
Inserting or replacing a water filter
A new water filter must be rinsed before
it can be used.
1. Select "Water filter" in the Settings
menu.
Use the navigation button to select
2.
"insert" or "replace".
Appliance reset to factory set-
tings
on
■
off
■
activate
■
Child-proof lock activated
■
To switch off, press milk
Resets all your own settings to the condition
when delivered.
For presentation purposes only. The setting "off"
must be activated for normal operation. The set-
ting is only possible in the first 3 minutes after
switching on the appliance.
Setting that governs whether the child-proof
lock is activated or deactivated. ~ "Childproof
lock" on page 21
Use the measuring spoon to press
3.
the water filter firmly into the empty
water tank.
Fill the water tank with water up to
4.
the "max" marking.
5. Place a container with a capacity of
at least 1.0 l under the outlet and
confirm.
Water will now flow through the filter.
The filter is rinsed.
6. Then empty the container.
The appliance is ready for use again.
Settings en
23