LG CF181D Owner's Manual page 33

Replacing the Lamp
1
Turn off the projector and unplug the power
cable. Carefully place on a cushioned surface.
(Allow the lamp to cool for 1 hour before removing
the used lamp from the projector.)
After lifting the lamp cover off, remove the two
3
retaining screws on the lamp case with a
screwdriver.
Screws
5
Pull out the handle slowly and remove the
lamp case.
7
Tighten the screws you removed in step 3.
(Make sure they are fixed firmly.)
• Using another manufacturers lamp may cause damage to the projector or lamp.
• Make sure the lamp cover is securely fastened. If the lamp cover is not installed correctly the unit will not power on.
• If this fault persists contact an LG Authorized Service Center.
2
Unscrew the screw from the lamp cover using
a screwdriver.
Lamp cover screw
4
Lift the lamp up from the projector.
bottom
Insert the new lamp gently into the correct
6
position. Push the lamp bottom to check if it
is correctly installed.
8
Close the lamp cover and install the screws
from step 2 to install the cover.
(If the lamp cover is not installed correctly the unit
will not power on.)
Information
Knob
33