LG LRH7080D Series Owner's Manual page 23

You can adjust the focus of a camera
manually.
You can adjust the iris of a camera
manually.
Displays or disappear the preset
control options in the virtual PTZ
remote control
Displays the Selected Preset number.
To input the preset number.
y
To register preset positions.
To delete a memorized preset
r
position.
To move the camera to the preset
t
position.
u
To start a preset tour.
Confirm the preset position.
NOTE
You can use some options by clicking the right button of the
mouse in PTZ camera control .
• PTZ Control Guide: Shows the guide for using the mouse.
• Exit: Exits from the PTZ camera control mode.
The IP camera which is connected by Onvif driver is not supported
Focus and Iris function on the PTZ operation.
Preset Settings
Preset position is the function to register camera monitoring
positions (preset positions) associated with position numbers.
By entering the position numbers, you can move cameras to the
preset positions.
NOTE
• To activate this function, you need to register the preset
positions of the PTZ cameras.
• ONVIF preset may not be operated properly with this unit.
To Register Preset Positions
1. Move the camera to a point you wish by using the
, , , buttons.
y
2. Press SET or click the icon.
3. Select the preset number you wish to register.
4. Press OK or click the
The position and its number are memorized.
5. Repeat steps 1 to 4 to add additional positions.
NOTE
Preset numbers from 0 to 255 are available on this unit but the
actual preset range differs depending on PTZ cameras.
Changing to a Picture in a Preset Position
The following function is available only with cameras provided with
the preset function. The preset function makes the combination
camera move to the programmed preset position. It is necessary to
program preset positions for the combination camera beforehand.
1. Press the MOVE button or click the
2. Use number buttons to enter the memorized preset position's
index number then press OK or click the
The camera moves to the preset position and the picture of the
camera in that position appears on the monitor.
To Clear the Preset Position
You can clear a memorized preset position.
1. Press the CLEAR button or Click the
2. Use number buttons to enter the memorized preset index
number then press OK or Click the
clear the preset positions.
NOTE
This function may not be available depending on PTZ cameras.
Installation
icon.
t
icon.
icon.
r
icon.
icon to
23
3