Additional Features - A.O. Smith T-H3S-DV Installation Manual And Owner's Manual

You can get some information about the water heater condition by pressing the "INFO" button. For more
information, follow the procedures below:
First of all, inlet water temperature will be displayed
1.
on the controller by pressing the "INFO" button.
Outlet water temperature will be displayed on the
2.
controller by pressing the "INFO" button.
And then, water flow will be displayed on the
3.
controller by pressing the "INFO" button.
4.
Press the "INFO" button to finish information mode.
The remote controller has a function that can change units of temperature and flow rate from °F to °C and
from gallon per minute to liter per minute and vice versa, please follow the procedures below:
Press the "ON/OFF" button on the controller in
1.
order to turn the controller on.
2.
When ON, the orange LED is lit.
The previous set temperature will be displayed on
3.
the screen.
4.
Press the "INFO" buttons for at least 3 seconds.
The set temperature should now be displayed in the
5.
alternate unit of measurement.
When the water heater is connected with the remote controller, the temperature
controller will not operate temperature settings, as only work for the information
mode (Indoor models only).
Downloaded from http://GadgetsGo.com Authorized Dealer

ADDITIONAL FEATURES

-Information mode-
Operation
-Unit conversion mode-
Operation
46
Screen on the controller
Temperature controller
Screen on the controller
Temperature controller
Page
Owner's Guide
Normal Operation
Remote controller
Inlet water temperature
(EX.: 60 °F)
Outlet water temperature
(EX.: 120 °F)
Water flow
(EX.: 3.5 GPM)
Remote controller
(EX.: 100 °F)
(EX.: 38 °C)