Table of Contents
Advertisement
en
Switching off
and disconnecting
the appliance
Switching the appliance off
Press the On/Off button.
Pull out the mains plug.
Disconnecting the appliance
If you do not use the appliance for a prolonged period:
1. Before switching off, it is most important that you
switch the water supply to the appliance off for a few
hours.
2. Take all food out of the appliance.
3. Switch the appliance off.
4. Pull out mains plug or switch off fuse.
5. Empty and clean the ice cube container (see chapter
Cleaning the appliance).
6. Clean the appliance interior (see chapter Cleaning
the appliance).
7. Leave the appliance doors open to prevent odours
from forming.
Defrosting
Defrosting is actuated automatically.
Cleaning the appliance
ã=
Warning
Never clean the appliance with a steam cleaner!
ã=
Caution
Do not use abrasive or acidic cleaning agents
■
and solvents.
Do not use scouring or abrasive sponges. The
■
metallic surfaces could corrode.
Never clean shelves and containers in
■
the dishwasher. The parts may become deformed!
Proceed as follows:
1. Before cleaning: Switch the appliance off.
2. Pull out the mains plug or switch off the fuse.
3. Take out the frozen food and store in a cool location.
Place the ice pack (if enclosed) on the food.
4. Clean the appliance with a soft cloth, lukewarm
water and a little pH neutral washing-up liquid. The
rinsing water must not run into the light.
5. Wipe the door seal with clear water only and then
wipe dry thoroughly.
6. After cleaning reconnect and switch the appliance
back on.
7. Put the frozen food back in the freezer compartment.
16
Interior fittings
All variable parts of the appliance can be taken out
for cleaning (see chapter Interior fittings).
Cleaning the ice cube container
If ice cubes have not been dispensed for a prolonged
period, they will shrink, have a stale taste and stick
together. Therefore, the ice cube container should be
cleaned regularly.
ã=
Caution
A full ice cube container is heavy.
1. Remove the ice cube container.
2. Pull out the container, empty and clean with
lukewarm water.
3. Thoroughly rub the container and screw conveyor
(for appliances with Agitation function) dry so that
new ice cubes cannot freeze to them.
4. Insert ice cube container and push back until it
engages. If the container cannot be pushed all
the way back, twist the screw conveyor
in the container.
Ice cube production continues.
Advertisement
Table of Contents
