Questions About Operations And Functions - Yamaha Clavinova CLP-280 Owner's Manual

Questions about Operations and
Functions
The buttons do not respond.
While you are using a function, some buttons not
used for the function are disabled. If the song is play-
ing, stop the playback. Otherwise, press the [EXIT]
button to return to the main screen. Then, perform
the desired operation.
The sound sustains indefinitely and does not
decay when I press the sostenuto pedal.
With the voices in the CHURCH ORGAN, JAZZ
ORGAN, STRINGS, CHOIR group, or some voices
in the XG group, the sound continues sustaining
while you are holding down the sostenuto pedal.
Higher or lower notes does not sound cor-
rectly when the transpose or octave setting
is made.
The setting range for the transposition and octave
setting is C-2 - G8. (With the normal setting, the
Clavinova's 88 keys covers the range of A-1 - C7.) If
the lowest key is set to a note lower than C-2, it will
produce a sound one octave higher. If the highest key
is set to a note higher than G8, it will produce a
sound one octave lower.
How can I return to the recording or song
select screen during song recording or play-
back?
Press the [SONG SELECT] button once.
The tempo does not change even though I
recorded with tempo changes.
Depending on the timing of tempo changes, the
changed tempo may not be recorded. In this case,
the recording will be played back at the original
tempo.
Make tempo changes when the recording part is
selected and a red part indicator is flashing. The
same trick applies to editing the tempo after record-
ing.
Performance in Dual or Split mode is not
recorded.
Part data is lost unexpectedly.
For Dual or Split mode recording, the recording part
for the second voice (that is, the voice for the left-
hand part) is automatically assigned (page 29).
Therefore, if the part already has data, the data will
be overwritten during recording. Also, switching to
Dual mode or Split mode in the middle of the song
is not recorded. Therefore, the notes you played with
the second voice (or the notes lower than the Split
point) are not recorded.
What type of data is recorded?
Data recorded in the parts:
• Note data (notes you play)
• Voice selection
• Clavinova pedals and external pedal on/off
• Reverb depth [ReverbSend]
• Chorus depth [ChorusSend]
• DSP effect depth [DSPDepth]
• Sound brightness [Brightness]
• Resonance effect setting [HarmonicContent]
• Equalizer's low-range frequency setting [EQLow-
Freq.]
• Equalizer's low-range gain setting [EQLowGain]
• Equalizer's high-range frequency setting
[EQHighFreq.]
• Equalizer's high-range gain setting [EQHighGain]
• Octave setting of the voice [Octave]
• Volume setting of each voice [Volume]
• Left/right position of each sound [Pan]
• Fine pitch adjustment between two voices (Dual
only) [Detune]
• Volume change in response to playing strength for
each voice [TouchSense]
Data recorded globally in all parts:
• Tempo
• Time signature
• Reverb type
• Chorus type
• DSP effect type
You can change all data except for note data, Octave
setting or Time Signature after recording.
CLP-280/270 Owner's Manual
99