Smeg SI1M7733B User Manual page 17

Problem
The heat setting changes
between two levels.
The sensor fields become
hot.
There is no sound when you
touch the panel sensor
fields.
comes on.
comes on.
comes on.
and a number come on.
You can hear a constant
beep noise.
If you cannot find a solution...
If you cannot find a solution to the problem
yourself, contact your dealer or an
Authorised Service Centre. Give the data
from the rating plate. Give also three digit
letter code for the glass ceramic (it is in
the corner of the glass surface) and an
Possible cause
Power management oper‐
ates.
The cookware is too large or
you put it too near to the
controls.
The sounds are deactivated.
Automatic Switch Off oper‐
ates.
Child Safety Device or Lock
operates.
There is no cookware on the
zone.
The cookware is unsuitable.
The diameter of the bottom
of the cookware is too small
for the zone.
There is an error in the hob.
The electrical connection is
incorrect.
error message that comes on. Make sure,
you operated the hob correctly. If not the
servicing by a service technician or dealer
will not be free of charge, also during the
warranty period. The instructions about
the Service Centre and conditions of
guarantee are in the guarantee booklet.
Remedy
Refer to "Daily use".
Put large cookware on the
rear zones if possible.
Activate the sounds. Refer
to "Daily use".
Deactivate the hob and acti‐
vate it again.
Refer to "Daily use".
Put cookware on the zone.
Use suitable cookware. Re‐
fer to "Hints and tips".
Use cookware with correct
dimensions. Refer to "Tech‐
nical data".
Deactivate the hob and acti‐
vate it again after 30 sec‐
onds. If comes on again,
disconnect the hob from the
electrical supply. After 30
seconds, connect the hob
again. If the problem contin‐
ues, speak to an Authorised
Service Centre.
Disconnect the hob from the
electrical supply. Ask a
qualified electrician to check
the installation.
17