Before First Use; Daily Use - Zanussi ZDC8203WZ User Manual

3. Press and hold buttons (B) and (D) at the same
time.
One of the these indicators comes on:
• the maximum dry laundry
• the more dry laundry
• the standard dry laundry

BEFORE FIRST USE

Before you use the appliance for the first time:
• Clean the tumble dryer drum with a moist cloth.

DAILY USE

START A PROGRAMME WITHOUT DELAY
START
1. Prepare the laundry and load the appliance.
CAUTION! Make sure that when
you close the door, the laundry
does not get caught between the
appliance door and the rubber
seal.
2. Press the on/off button to activate the
appliance.
3. Set the correct programme and options for the
type of load.
The display shows the programme duration.
The drying time you see on the display,
when the cotton programme is
selected, is related to the load of 5 kg
and standard conditions . Real drying
time will depend on type of the load
(quantity and composition), the room
temperature and the humidity of your
laundry after spin drying phase.
4. Press the Start/Pause touch button.
The programme starts.
STARTING THE PROGRAMME WITH DELAY
START
1. Set the correct programme and options for the
type of load.
2. Press the delay start button again and again
until the display shows the delay time you want
to set.
You can delay the start of a
programme from a minimum of 60
minutes to a maximum of 20
hours.
3. Press the Start/Pause touchpad.
10
4. Press the button (F) again and again until the
indicator of the correct level comes on.
5. To confirm the adjustment, press and hold
buttons (B) and (D) at the same time for
approximately 2 seconds.
• Start a 1 hour programme with moist laundry.
The display shows the countdown of the delay
start.
When the countdown is completed, the programme
starts.
CHANGE A PROGRAMME
1. Press the on/off button to deactivate appliance
2. Press the on/off button to activate the
appliance.
3. Set the programme.
AT THE END OF THE PROGRAMME
When the programme is completed:
• An intermittent acoustic signal operates.
• The indicator flashes.
• The indicators Filter and
• The Start/Pause indicator is on.
The appliance continues to operate with the crease
guard phase for approximately other 30 minutes.
The crease guard phase removes creases from
your laundry.
You can remove the laundry before the crease
guard phase is completed. We recommend, for
better results, that you remove the laundry when the
phase is almost completed or completed.
When the crease guard phase is completed:
• The indicator is on but does not flash.
• The indicators Filter and
• Start/Pause indicator goes off.
1. Press the on/off button to deactivate the
appliance.
2. Open the appliance door.
3. Remove the laundry.
4. Close the appliance door.
Tank comes on.
Tank comes on.