Table of Contents
Advertisement
BEFORE FIRST USE
Before you use the appliance for the first time do
these operations:
•
Clean the tumble dryer drum with a moist cloth.
DAILY USE
START A PROGRAMME
1. Prepare the laundry and load the appliance.
CAUTION! Make sure that when
you close the door, the laundry
does not catch between the
appliance door and the rubber
seal.
2. Set the correct programme and options for the
type of load.
3. Press the Start/Pause touchpad.
The programme starts.
CHANGE A PROGRAMME
1. Turn the Programme knob to
2. Set the programme.
AT THE END OF THE PROGRAMME
When the programme is completed:
•
An intermittent acoustic signal operates.
•
The indicators Drying, End/Anticrease, Filter and
Tank comes on.
•
The Start/Pause indicator is on.
The appliance continues to operate with the crease
guard phase for approximately other 30 minutes.
The crease guard phase removes creases from
your laundry.
You can remove the laundry before the crease
guard phase is completed. We recommend, for
better results, that you remove the laundry when the
phase is almost completed or completed.
When the crease guard phase is completed:
•
The indicators Drying, End/Anticrease, Filter and
Tank comes on.
HINTS AND TIPS
PREPARING THE LAUNDRY
•
Close the zippers.
•
Close the fasteners of the duvet covers.
•
Do not keep ties or ribbons loose (e.g. apron
ribbons). Tie them before you start a
programme.
•
Remove all items from the pockets.
8
•
Start a short programme (e.g. 30 minutes) with
moist laundry.
•
Start/Pause indicator goes off.
1. Turn the Programme knob to
2. Open the appliance door.
3. Remove the laundry.
4. Close the appliance door.
STAND-BY FUNCTION
To decrease the energy consumption, this function
automatically deactivates the appliance:
•
After 5 minutes if you do not start the
OFF
programme.
•
After 5 minutes from the end of the programme.
INDICATOR LIGHTS
These lights indicate the following functions:
•
Drying: This light indicates that the appliance is
in the drying phase.
•
End/Anticrease: This light is on at the end of
the cooling phase, during the anticreasing
phase and at the end of the programme.
•
Filter: This light illuminates at the end of the
programme to remind you that the filters must
be cleaned.
•
Condenser : This light indicate that the
condenser must be cleaned.
•
Tank: This light comes on at the end of the
programme to remind you that the water
reservoir must be emptied out. This light comes
on also when the water reservoir is not inserted
correctly.
•
If an item has the internal layer made of cotton,
turn it inside out. Make sure that the cotton layer
is always external
•
We recommend that you set the correct
programme applicable for the type of fabrics
that are in the appliance.
Always clean the filter and empty the
water container when a programme is
completed.
OFF
Advertisement
Table of Contents
