Philips FC7070/61 User Manual page 23

Problem Possible cause
The mopping nozzle
lid is not closed prop-
erly. The sound of the
appliance decreases and
the appliance no longer
applies water to the floor
because the mopping
brushes do not rotate
and the appliance does
not mop up anything.
I cannot close the The mopping brush
mopping nozzle cover is not present or is
lid. not placed properly.
The appliance You have moved the ap-
leaves water pliance sideways.
traces on the
floor.
You have moved the ap-
pliance across a threshold
while it was switched on.
You have moved the
appliance with its nozzle
touching the floor while
it was switched off.
You lifted the appliance
up from the floor imme-
diately after you switched
it off.
The wheels are blocked.
Solution
Make sure the mopping brushes and the mopping
brush cover are assembled correctly. Close the mop-
ping nozzle lid properly. Make sure you press the lid
until it locks with a click (see chapter 'Cleaning and
maintenance', section 'Reassembling the mopping
nozzle').
Place the mopping brush cover into the mopping
nozzle properly and then close the mopping nozzle
lid (see chapter 'Cleaning and maintenance', section
'Reassembling the mopping nozzle').
Only move the appliance forwards and backwards
(see chapter 'Using your Aqua Trio', section 'Cleaning
tips').
Make sure the mopping brushes stay in contact with
the floor. Switch off the appliance before you pull
it over a threshold to prevent water traces on the
floor or to prevent water from splashing from the
mopping nozzle (see chapter 'Using your Aqua Trio',
section 'Cleaning tips').
If you want to avoid water traces on the floor, move
the appliance by carrying it by its carrying handle
or by tilting it so that it rests on its wheels for easy
transport (see chapter 'Storing and moving your
AquaTrio').
After you switch off the appliance, move it forwards
and backwards a few times to remove the liquid that
is present between the two mopping brushes. If you
switch off the appliance and lift it up immediately
afterwards, the water that was present between the
brushes leaves a trace of water on the floor.
Check the condition of the wheels. Remove the dirt
that blocks the wheels.
23