Philips AVENT SCD620/52 Manual page 25

HOW TO USE / CONNECTING THE UNITS
How can I reset the
parent unit?
INDICATIONS ON THE PARENT UNIT
Question
The battery LED on the
parent unit turns red.
What should I do?
Why does the parent
unit beep?
What does the battery
LED colour (green,
orange, red) or no
burning LED mean for
the status of my
battery?
NOISE/SOUND
Question
Why does the parent
unit and/or baby unit
produce a high-pitched
noise?
You can reset the parent unit by simultaneously press the "power on/off
button" and the round "navigation down button" at the front of the parent
unit for about 1 second. The parent unit will switch off. In order to turn the
parent unit back on, press the "power on/off button". Specific user
information stored in the memory of the parent unit such as user mode,
brightness settings, volume, lullaby selection, zoom selection and vibration
settings will not be lost.
Answer
The battery power is low. If you do not connect the parent unit to the mains
power when the battery LED has turned red and starts to make a beeping
sound, the unit will stop working after approximately 60 minutes.
Switch to lower brightness and/or volume to save battery consumption and
connect the parent unit to the mains with the power adapter. (see chapter
'Preparing for use').
Your baby monitor beeps in a certain way to tell you what the problem is.
1 beep: parent unit is switched off.
1 beep, every 20 seconds for the first 3 minutes, after that, every minute:
parent unit is low in battery.
3 quick beeps every 20 seconds: connection between parent and baby unit
is lost, link icon is shown on the parent unit's screen and the link connection
button is red.
When the parent unit is connected to the mains power the color of the
battery light will show:
* Green: battery is full.
* Orange: battery is charging.
When the parent unit is not connected to the mains power the color of the
battery light will show:
* Red: battery is almost empty (<10 %).
* No burning LED: parent unit is not connected to the mains.
Answer
The parent unit and baby unit may be too close to each other. Make sure
the parent unit and the baby unit are at least 2.5 meters / 8.2 feet away
from each other.
The volume of the parent unit may be set too high. Decrease the volume of
the parent unit.
25
English