Attaching the Base
You must attach the base to the Unit to have it as a table top Unit.
Be sure the front and rear of the base match the proper direction. For
large screen TVs, at least 2 people are required for these steps.
1
3
× 4
2
Note(s)
Make sure to use a table which can support the weight of this Unit and is larger than this
●
Unit.
Make sure the table is in a stable location.
●
When attaching the base, ensure that All Screws are tightly fastened. If the base is not
●
properly attached, it could cause the Unit to fall, resulting in injuries as well as damage to
the Unit.
To remove the base from this Unit, unscrew the Phillips-head screws by reversing the
●
procedure. Be careful not to drop the base when you remove it.
1
2
Installing the Remote Control Batteries
1
Slide the battery cover off the back of the Remote Control.
2
Insert 2 Supplied Batteries (AAA, 1.5V). Be sure the + and – ends
of the Batteries line up with the markings inside the case.
3
Slide the cover back into position.
Note(s)
Remove the Batteries if not using the Remote Control for an extended period of time.
●
9
.
English
Continued on next page.