RIDGID R4110 Operator's Manual page 11

FEATURES
LASER GUIDE SWITCH
See Figure 3.
Use the laser guide switch to turn the laser guide on and off.
MITER LOCK KNOB
The miter lock knob securely locks the saw at the desired
miter angle. To release the saw, loosen the miter lock knob
and depress the miter lock plate.
POSITIVE STOPS ON MITER TABLE
Positive stops have been provided at 0°, 15°, 22.5°, 31.6°,
and 45°. The 0°, 15°, 22.5°, 31.6°, and 45° positive stops
have been provided on both the left and right side of the
miter table.
SELF-RETRACTING LOWER BLADE GUARD
The lower blade guard is made of shock-resistant, see-
through plastic that provides protection from each side of
the blade. It retracts over the upper blade guard as the saw
is lowered into the workpiece.
SPINDLE LOCK BUTTON
See Figure 4.
A spindle lock button has been provided for locking the
spindle which keeps the blade from rotating. Unplug the saw.
Depress and hold the lock button while installing, changing,
or removing blade only.
SLIDING MITER FENCE
The sliding miter fence on your compound miter saw has
been provided to hold your workpiece securely against when
making all cuts; the left side is larger providing additional
vertical support. It has a sliding feature for clearance of the
saw arm when making bevel or compound cuts.
Loosen the fence screw before attempting to slide the miter
fence. Once the desired position of the miter fence is deter-
mined, tighten the fence screw to secure the sliding fence.
SWITCH TRIGGER
See Figure 5.
To prevent unauthorized use of the compound miter saw,
disconnect it from the power supply and lock the switch in
the off position. To lock the switch, install a padlock (not
included) through the hole in the switch trigger. A lock with
a long shackle up to 9/32 in. diameter may be used. When
the lock is installed and locked, the switch is inoperable.
Store the padlock key in another location.
WORK CLAMP STORAGE
See Figure 6.
A work clamp has been included with this saw to hold mate-
rial in place during cutting applications. A storage area for
the work clamp is located on the base of the saw.
SWITCH
TRIGGER
SPINDLE
LOCK
BUTTON
PADLOCK
11
SWITCH
TRIGGER
WORK CLAMP
STORAGE
Fig. 4
Fig. 5
WORK
CLAMP
Fig. 6