Samsung HG43NE590 Installation Manual page 25

Hotel TV Function
Category Item
REACH
REACH IP Mode
Server IP Setting
REACH Channel
REACH Update Time
REACH
Solution
REACH Update
Immediate
Group ID
Room Number
IPG Room Type
REACH Config Version The version of REACH is displayed.
Network Setup
Network
SmartHub Model
Setting
SmartHub Setting
Service Discovery
VLAN ID
Solution VLAN ID
Device VLAN ID
y ON: The feature of REACH in this TV becomes available.
y OFF: The feature of REACH in this TV becomes not available.
If enabled, Reach will work over IP instead of RF.
The URL of the Reach IP server, for example https:\\192.168.1.2:443.
Assign a DTV channel number to carry the update REACH data. This channel number must be the
same as the number set on the Reach server.
Lets you set when data such as updated SW, cloning files, and S-LYNC REACH contents is
downloaded from the REACH server to the TV :
y 1hour: Every hour
y 2hour: Every 2 hours
y 12:00 am: every 12:00 a.m.
y 2:00 am: every 2:00 a.m.
y 12:00 pm: every 12:00 p.m.
y 2:00 pm: every 2:00 p.m.
y ON: Whenever the TV enters standby mode (the power cord is plugged in and the power is off),
the REACH data is updated on the TV.
y OFF: The REACH data is only updated on the TV at the REACH server update time.
Select the group ID of the REACH server. (Refer to the REACH server manual for more details)
Set the room number
Selects the IPG room type of the REACH server. (Refer to the REACH server manual for the more
information.)
If this item is entered into, network setup menu is displayed. The network setup menu is used
for setting network like access internet.
Soft AP: Using this function, you can connect the TV on your mobile devices. Set the options for
connection of Wi-Fi device.
y Soft AP: Turns on or off the Soft AP. When Soft AP is set to On, your mobile devices can find the
TV name in Wi-Fi connection list.
y Security key: Set a security key that you need to enter on other devices so they can connect to
the TV.
– Input the generated security key into the device you want to connect.
– If network does not operate normally,check the security key again. An incorrect
security key may cause a malfunction.
✎ Soft AP may not be available if it is not supported by the model.
✎ Maximum number of devices that can be connected: 4 devices.
✎ Bitrate : 10 Mbps/device.
✎ The specifications above are based on our in-house testing. Actual performance may vary
depending on your wired/wireless network environment.
Set SmartHub Model.
Set up SmartHub.
Can use this feature to enable Service Discovery Features like DLNA.
Create separate VLAN groups. A 3-digit number can be entered between 1 and 255 for the VLAN
ID.
When VLAN is used, set a VLAN ID to be assigned to a Solution (such as SYNC, H.Browser etc.).
Set a VLAN ID to be assigned to external devices connected to the LAN OUT port.
Description
25
English