Table of Contents Warnings and Important Information _______________________________ 3 Dimensions _____________________________________________________ 6 Specifi cations ___________________________________________________ 7 Cutout Dimensions ______________________________________________ 8 General Information ______________________________________________ 9 Installation _____________________________________________________ 10 Performance Checklist ___________________________________________ 14 Control Panel __________________________________________________ 14 Service & Registration ___________________________________________ 15...
IMPORTANT – Please Read and Follow! • Before beginning, please read these Your safety and the safety of others is instructions completely and carefully. very important. • DO NOT remove permanently affi xed We have provided many important safety labels, warnings, or plates from product. messages in this manual and on your This may void the warranty.
Page 4
IMPORTANT – Please Read and Follow! A GFI shall be used if required by NFPA-70 (National Electric Code), federal/state/local laws, or local ordinances. • The required use of a GFI is normally related to the location of a receptacle with respect to any signifi...
Page 5
IMPORTANT – Please Read and Follow! WARNING DANGER To prevent possible damage to cabinets ELECTRICAL SHOCK and cabinet fi nishes, use only materials HAZARD and fi nishes that will not discolor To avoid risk of electrical shock, or delaminate and will withstand personal injury or death;...
General Information Recommendations for • All openings in the wall behind the appliance or in the fl oor under the appliance should be Moving sealed. • The appliance is heavy – use extreme care • Keep appliance area clear and free from when handling! combustible materials, gasoline and other fl...
Installation • BE SURE that support for this appliance Attach the skid plate before installing the is perpendicular to the front facing of the two slide rails. If possible, the rails should wall or cabinet before you perform the be placed on top of any studs that might be installation.
Page 11
Headline Installation (cont.) Open lower oven door completely. Fold latches backward until locked in place Lift door up and out. Slowly close until latches stop door. Remove racks. Unscrew pallet screws from side of oven.
Page 12
Headline Installation (cont.) WARNING ELECTRICAL FIRE HAZARD White Improper connection of aluminum house Neutral Green wiring to copper leads can result in an electrical hazard or fi re. Use only connectors designed for joining copper to Black aluminum and follow the manufacturer's recommended procedure closely.
Page 13
Headline Installation (cont.) Remove center grille by removing screws underneath Attach screws thru the framing from front of unit on grille. Push grille up and pull out. both sides in the center and bottom. There are no mounting holes at the top Replace center grille by pushing in and down.
Performance Checklist – Lower Oven Headline Loading the Software This fi rst time you turn on the oven after installation, the oven will load the software. This process should take no longer than 10 minutes. DO NOT attempt to operate the oven while the software is loading.
Service & Registration Headline If service is required, call your authorized service agency. Have the following information readily available. • Model number • Serial number • Date purchased • Name of dealer from whom purchased Clearly describe the problem that you are having. If you are unable to obtain the name of an authorized service agency, or if you continue to have service problems, contact Viking Range, LLC at 1-888-(845-4641), or write to: VIKING RANGE, LLC...
Page 16
Viking Range, LLC 111 Front Street Greenwood, Mississippi 38930 USA (662) 455-1200 For product information, call 1-888-(845-4641) or visit our web site at vikingrange.com in the US or brigade.ca in Canada F21300B EN (040116)