Table of Contents
Advertisement
Positioning and connecting
en
Before washing for the first
time
The washing machine was thoroughly
tested before leaving the factory. In
order to remove any water which may
be left over from the test, run the first
washing cycle without any laundry.
Notes
The washing machine must be
■
correctly installed and connected.
(from ~ Page 39).
Never use a damaged machine.
■
Inform customer services.
Preparatory work:
Check the machine.
1.
Remove the protective film from the
2.
control panel.
Connect the mains plug.
3.
Turn on the tap.
4.
Run the programme without laundry:
Switch on the appliance.
1.
Close the door (do not load any
2.
laundry).
Set the Drum Clean 90 °C
3.
programme.
Open the detergent drawer.
4.
Pour approximately 1 litre of water
5.
into compartment II.
Pour standard detergent into
6.
compartment II.
To prevent foaming, only use
Note:
half of the amount of detergent
recommended by the detergent
manufacturer. Do not use detergents
designed for woollens or delicates.
Close the detergent drawer.
7.
Press the Ü button.
8.
Switch off the appliance at the end of
9.
the programme.
Your washing machine is now ready to
use.
46
Transportation
E.g. when moving house
Preparatory work:
Turn off the tap.
1.
Reduce the water pressure in the
2.
supply hose: ~ Page 31; Cleaning
and maintenance – filter in the water
supply blocked
Disconnect the washing machine
3.
from the mains.
Drain the remaining water:
4.
~ Page 30; cleaning and
maintenance – the drain pump is
blocked, emergency draining
Remove the hoses.
5.
Installing the transport braces:
Remove the covers and keep them
1.
in a safe place.
Use a screwdriver if necessary.
Insert all four sleeves.
2.
Clip the mains cable securely in the
holders. Insert and tighten the
screws.
Advertisement
Table of Contents
