Table of Contents
Advertisement
Setting Auto Initialize
¦
When you clone settings from one TV to another, you clone both the guest side menu and hotel side menu settings:
Picture, Sound, Input, Channel, Setup, and Hotel Setup). This lets you set nearly all of the menu values on your hospitality
TVs to the same, standard settings. If you allow guests access to the guest side menus, for example the Picture menu,
they can change the settings in those menus so they are no longer standard. If you set the Setting Auto Initialize function
to on, the TV automatically restores (initializes) any guest-side menu values to the cloned, standard values when the TV
is turned off and then turned on again. Note that Setting Auto Initialize works on cloned guest side menu values only.
Settings which have not been cloned are ignored.
The table below lists the settings that are restored to their cloned values when you set the Setting Auto Initialize function
to on.
Picture
Picture Mode
Picture Size Settings
Expert Settings
Menu Item
Picture Size
Auto Wide
4:3 Screen Size
Fit to Screen
Zoom and Position
Backlight
Brightness
Contrast
Sharpness
Color
Tint (G/R)
Apply Picture Settings
Digital Clean View
LED Clear Motion
Contrast Enhancer
Film Mode
Color Tone
White Balance
Gamma
RGB Only Mode
Colour Space Settings
2 Point
10 Point Settings
Colour Space
Colour
Red
Green
Blue
R-Gain
G-Gain
B-Gain
R-Offset
G-Offset
B-Offset
10 Point
Interval
Red
Green
Blue
33
English
Advertisement
Table of Contents
