Advertisement
CD Player
Playing a CD
This CD player plays Audio Discs including
CD-Recordables and CD-Rewritable.
•
MP3 CD-ROMs, CD-I, CDV,VCD, DVD or
computer CDs are not possible for playback
on this set.
IMPORTANT!
CDs encoded with copyright protection
•
technologies by some record companies may
be unplayable by this product.
For a disc with CD Audio tracks and MP3
•
files, only the CD Audio tracks will be played.
1 Adjust the source selector to CD.
2 Open the disc door.
3 Insert a CD with the printed side facing up
and press the CD door gently to close.
➜ Display shows -- and later, the total
number of tracks. (See 2, 3)
4 Press 2; on the set to start playback.
➜Display: 2 and the current track number.
(See 4)
5 To pause playback press 2;. To resume
playback, press 2; again.
6 To stop CD play, press 9.
Helpful hints :
CD play will also stop when:
–
you open the CD compartment;
–
you select TUNER, or TAPE/OFF sound
source;
–
the CD has reached the end of playback.
6
Selecting a different track
• Press ∞ or § once or repeatedly until the
desired track number appears in the display.
• In the stop/pause position, press 2; to start
playback.
Finding a passage within a
track
1 During playback, press and hold down
∞/ §.
➜ The CD is played at high speed and low
volume.
2 When you recognize the passage you want
release ∞/ §.
➜ Normal playback resumes.
Helpful hints :
–
When your searching reaches the end of the
last track, the CD goes to stop mode.
CD Player
Programming track
numbers
You may store up to 20 tracks in the desired
sequence. If you like, store any track more
than once.
1 In the stop position, press PROG to activate
programming.
➜ Display: PROG and 00 flash (see 5).
2 Press ∞ or § to select your desired track
number.
➜ Display: PROG and your desired track
number flash.
3 Press PROG to store the desired track
number.
➜ Display: PROG and 00 flash for you to
program the next track.
4 Repeat steps 2 to 3 to select and store all
desired tracks in this way.
5 To play your program, press 2;.
➜ Display: PROG flashes during program
playback. Helpful hints :
–
If you try to store more than 20 tracks, no
track can be selected and the display will show
flashing --.
To review a program
•
In the stop position, press PROG repeatedly
to see your stored track numbers.
Erasing a program
You can erase the contents of the memory
by:
– in the stop position, press PROG to enter
program mode, and then press 9;
– Selecting TUNER or TAPE/OFF sound
source;
– opening the CD door.
➜Display: PROG disappears.
Different play mode
(See 6):
REPEAT
You can play the current track or the whole
disc repeatedly, and combine REPEAT modes
with PROGRAM.
REPEAT – plays the current track
continuously.
REPEAT ALL– repeats the entire
CD/program.
1
To select play mode, press REPEAT once or
more.
➜
The display shows selected
mode.
Press 2; to start playback if in the stop/pause
2
position.
3
To return to normal playback, press REPEAT
repeatedly until the modes are no longer
displayed.
– You can also press 9 to cancel your play
mode.
7
Advertisement
