Philips Saeco INCANTO HD8918 User Manual page 26

Problem
The coffee has too little
crema or is watery.
Coffee is leaking from the
coffee dispensing spout.
The coffee is not hot
enough.
The machine grinds the
coffee beans, but coffee
does not come out.
The coffee comes out
slowly.
Cause
The machine is still in the
descaling procedure.
The grinder is set to a too
coarse setting.
The coffee blend is not the
correct one.
The machine is performing its
self-adjustment procedure.
The brew group is dirty.
The coffee dispensing spout is
clogged.
The coffee exit duct is clogged. Clean the coffee exit duct.
The cups you use are cold.
The temperature is set too low.
Check the menu settings.
You added milk.
The coffee exit duct is blocked. Clean the coffee exit duct with the
The grinder is set to a too fine
setting.
The brew group is dirty.
The coffee dispensing spout is
dirty.
The grinder is set to a too fine
setting.
The brew group is dirty.
Solution
Reset the machine in the following way:
place the drip tray and the coffee
grounds container back. Leave the brew
group out. Close the service door and
switch the machine on and off. Then try
to reinsert the brew group.
You cannot remove the brew group
when the descaling procedure is active.
First complete the descaling process
and then remove the brew group.
Adjust the grinder to a finer setting.
Change the coffee blend.
Brew a few cups of coffee.
Clean the brew group.
Clean the coffee dispensing spout and
its holes with a pipe cleaner.
Preheat the cups by rinsing them with
hot water.
Set the temperature to 'high' in the
menu.
Whether the milk you add is warm or
cold, it always decreases the
temperature of the coffee to some
extent.
handle of the measuring spoon or a
spoon handle. Switch the appliance off
and on again.
Adjust the grinder to a coarser setting.
Clean the brew group.
Clean the coffee dispensing spout and
its holes with a pipe cleaner.
Use a different coffee blend or adjust
the grinder.
Clean the brew group.
English
25