Philips NORELCO S5570CC Manual page 14

ENGLISH
26
Preparing SmartClean System For
Use
CAUTION: Keep cleaning cartridge(s) out of
reach of children. Do not take internally. Avoid
contact with eyes. In case of eye contact,
thoroughly flush with cold water. If irritation
persists, get medical attention.
Important
Q For optimal cleaning results, replace the
cleaning cartridge every 3 months when used
weekly.
Q Only use this shaver, SmartClean System and
cleaning cartridge provided to charge or clean
shaver.
Q Other Philips Norelco shavers may not work
with this SmartClean System.
Q To avoid evaporation, do not expose cleaning
solution to direct sunlight.
Q The SmartClean System thoroughly cleans but
does not disinfect your shaver, therefore, do
not share shaver with others.
Q The charging plug converts 100-240V AC to
less than 24V DC.
Q Place the SmartClean System on a flat,
stable and fluid-resistant surface to avoid any
leakage. Be careful not to tip or move the
SmartClean System when it is ready for use.
Q Use this appliance for its intended household
use as described in this manual.
C
1 Place the SmartClean System on a flat, level
surface.
To prevent leaking, do not tilt the SmartClean
System.
C
While holding the SmartClean System with
2
one hand, press the button located on the
2
side of the SmartClean System (1) and lift
1
the SmartClean System (2).
C
Remove the seal off the cleaning cartridge.
3
NOTE: ONLY USE PHILIPS NORELCO
SMARTCLEAN CARTRIDGE (MODEL JC302
OR JC303) WITH THE SMARTCLEAN SYSTEM.
Q When the cleaning cartridge filter is full, the
replacement symbol blinks indicating the
cleaning cartridge should be replaced. See
'Replacing the SmartClean System Cartridge'.
C
4 Place the cleaning cartridge in the
SmartClean System.
C
5 While holding the SmartClean System with
one hand, gently push the top part of the
SmartClean System back down. You will
hear a 'click'.
ENGLISH
27