Set Up Easylink (Hdmi-Cec Control) - Philips HTD3500X User Manual

Option 1: Connect audio through a digital
optical cable
Best quality audio
Using an optical cable, connect the OPTICAL
connector on your home theater to the OPTICAL
OUT connector on the TV or other device.
The digital optical connector might be labeled
SPDIF, SPDIF OUT, or OPTICAL.
Option 2: Connect audio through analog
audio cables
Basic quality audio
Using an analog cable, connect the AUX
connectors on your home theater to the AUDIO
OUT connectors on the TV or other device.
Set up EasyLink (HDMI-CEC
control)
This home theater supports Philips EasyLink,
which uses the HDMI-CEC (Consumer Electronics
Control) protocol. EasyLink-compliant devices that
are connected through HDMI can be controlled
by a single remote control.
•
Depending on the manufacturer, HDMI-CEC is
known by many names. For information on your
device, see the user manual of the device.
•
Philips does not guarantee 100% interoperability
with all HDMI-CEC devices.
Before you start
•
Connect your home theater to the HDMI-
CEC compliant device through HDMI
connection.
•
Make the necessary connections described in
TV
the quick start guide, and then switch the TV
to the correct source for your home theater.
Enable EasyLink
1
Press
2
Select [Video Setup], and then press OK.
3
Select [HDMI Setup] >[EasyLink Setup] >
[EasyLink], and then press OK.
4
Select [On], and then press OK.
5
On your TV and other connected devices,
turn on HDMI-CEC control. For details, see
the user manual of the TV or other devices.
•
VCR
EasyLink controls
With EasyLink, you can control your home theater,
TV, and other connected HDMI-CEC compliant
devices with a single remote control.
• [One Touch Play] (One-touch play): When a
video disc is in the disc compartment, press
and then play a disc.
• [One Touch Standby] (One-touch standby):
If one-touch standby is enabled, your home
theater can switch to standby with the
remote control of the TV or other HDMI-
CEC devices.
•
[System Audio Control] (System audio
control): If system audio control is enabled,
the audio of the connected device is output
through your home theater speakers
automatically when you play the device.
•
[Audio Input Mapping] (Audio input
mapping): If system audio control does not
work, map the connected device to the
correct audio input connector on your home
theater (see 'Set up the audio' on page 10).
Note
SETUP.
On your TV, set the audio output to
'Amplifier' (instead of TV speakers). For
details, see the TV user manual.
(Play) to wake up the TV from standby,
EN
9