Table of Contents
Advertisement
Overview
The switch supports the Fabric Extenders (FEXs) listed at
https://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus9000/hw/interoperability/fexmatrix/fextables.html.
The following figure shows the hardware features seen from the port side of the chassis.
1
Console port (RS232 port)
2
Chassis LEDs
• Beacon (BCN)
• Status (STS)
• Environment (ENV)
3
Two USB ports used for saving or copying
functions
Note
Cisco Nexus 9396TX NX-OS Mode Switch Hardware Installation Guide
2
Note
Do not mix AC and DC power supplies in the same chassis.
Note
All fan modules and power supplies must use the same airflow direction during
operations. If you are using the 1200-W HVAC/HVDC power supply, the power
supply automatically uses the same airflow direction as used by the other modules
in the switch.
USB support is limited to USB 2.0
devices that use less than 2.5 W (less
than 0.5 A inclusive of surge current).
Devices, such as external hard drives,
that instantaneously draw more than
0.5 A are not supported.
6
M4PC-CFP2, M6PQ, M6PQ-E, or M12PQ uplink
module (M12PQ uplink module shown).
7
4-, 6-, or 12-port 40-Gigabit Ethernet Quad Small
Form-Factor Plugable (QSFP+) optical ports for
connections to other devices (12-port uplink
module shown)
8
Notch in both sides of the chassis for locking the
power supply end of the chassis to the
bottom-support rails
Overview
Advertisement
Table of Contents
