Philips RQ1150XNT User Manual page 18

ENGLISH
20
During the second phase of the cleaning program, the shaver is
,
placed in the drying position, indicated by the flashing drying symbol.
This phase takes approx. 2 hours. The shaver stays in this position
until the end of the program.
After the cleaning program, the charging indication appears on the
,
shaver display (see chapter 'The display').
Note: If you press the on/off button of the Jet Clean System during the cleaning
program, the program aborts. In this case, the cleaning or drying light stops
flashing and the holder moves to the highest position.
Note: If you remove the adapter from the wall socket during the cleaning program,
the program aborts. The holder remains in its current position. When you put
the adapter back into the wall socket, the holder moves to the highest position.
- When the cleaning fluid drops below the minimum level, the 'cleaning
chamber empty' symbol starts to flash and the holder returns to its
starting position.
- If you use the Jet Clean System to clean your shaver every day, you
need to refill the cleaning chamber approx. every 15 days.
Cleaning the Jet Clean System
Clean the cleaning chamber every 15 days.
You can wipe the outside of the Jet Clean System with a damp cloth.
1 Simultaneously press the release buttons on both sides of the Jet
Clean System (1). Then lift the Jet Clean System off the cleaning
chamber (2).
The cleaning chamber remains behind.
,
2 Pour any remaining cleaning fluid out of the cleaning chamber.
You can simply pour the cleaning fluid down the sink.
3 Rinse the cleaning chamber under the tap.
The cleaning chamber is not dishwasher-proof.