Table of Contents
Advertisement
3-4
Onboard Battery Installation
A battery is included on the mainboard to supply certain volatile memory components
with power when power has been removed from the blade module. If this battery dies, it
must be replaced with an equivalent CR2032 Lithium 3V battery. Dispose of used
batteries according to the manufacturer's instructions. See
installing a new onboard battery.
WARNING: There is a danger of explosion if the onboard battery is installed upside down,
which reverses its polarities.
3-5
Memory Installation
The mainboard of each blade unit must be populated with DIMMs (Dual In-line Memory
Modules) to provide system memory. The DIMMs should all be of the same size and
speed and from the same Super Micro authorized manufacturer due to
compatibility issues. See details below on supported memory and our web site
(www.supermicro.com/products/superblade
Populating Memory Slots
The mainboard of a SBI-7128R-C6/C6N blade module has sixteen (16) 288-pin DDR4
DIMM memory slots, eight for each processor. Both interleaved and non-interleaved
memory are supported, so you may populate any number of DIMM slots.
Populating two slots at a time (DIMM1A + DIMM2A, DIMM3A + DIMM4A, etc.) with
memory modules of the same size and of the same type will result in dual-channel,
interleaved memory, which is faster than single-channel, non-interleaved memory. See
Table 3-1: "Populating Eight Memory Slots for Interleaved Operation" on page 3-10
details.
WARNING: For an interleaved configuration, memory modules of the same size and
speed must be installed in pairs. You should not mix DIMMs of different sizes and
speeds.
Figure 3-12. Installing the Onboard Battery
Lithium Battery
Battery Holder
Chapter 3: Setup and Installation
Figure 3-12
for recommended memory.
3-9
for a diagram of
for
Advertisement
Table of Contents
