Related Manuals for Philips DS1600/98
Summary of Contents for Philips DS1600/98
- Page 1 Always there to help you Register your product and get support at www.philips.com/support DS1600 Question? Contact Philips User manual...
-
Page 3: Table Of Contents
Contents 1 Important Safety Notice 2 Your Docking Speaker Introduction What's in the box Overview of the main unit 3 Get started Connect power Turn on 4 Play Play audio from iPod/ iPhone/ iPad Play through an audio cable Other features Update the firmware 5 Product information Specifications... -
Page 4: Important
Please visit www.recycle.philips.com for fallen into the device, the device has been additional information on a recycling center in exposed to rain or moisture, does not your area. - Page 5 packaging materials, exhausted batteries and old equipment. The making of unauthorized copies of copy- protected material, including computer programs, files, broadcasts and sound recordings, may be an infringement of copyrights and constitute a criminal offence. This equipment should not be used for such purposes.
-
Page 6: Your Docking Speaker
2 Your Docking Overview of the main unit Speaker Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome. Introduction With DS1600, you can: • enjoy audio from your iPod/iPhone/iPad;... - Page 7 h Display panel • Adjust volume. j Toggle switch for lightning/30-pin control • Adjust brightness of display and bottom light.
-
Page 8: Get Started
3 Get started Switch to standby mode DS1600 switches to standby mode in the following situations: Always follow the instructions in this chapter in • In dock mode: no audio signal from the sequence. docked iPod/iPhone/iPad over 15 minutes. In AUDIO IN mode: no audio signal •... -
Page 9: Play
4 Play Switch the dock Switch the dock between the lightning connector and 30-pin connector for different generation of Apple device. Slide the switch to the right. Play audio from iPod/ iPhone/ » The dock swivels and the alternate iPad connector is accessible. -
Page 10: Play Through An Audio Cable
When using DS1600 for the first time, a Listen to the iPod/ iPhone/ iPad required software application automatically pops up. Note • Make sure that the iPod/ iPhone/ iPad is loaded correctly. • Start music play in your iPod/ iPhone/ iPad. »... -
Page 11: Other Features
To set time format: Charge your mobile phone In standby mode, press TIME/DATE to Charge your mobile phone through the USB display time. socket in DS1600 with a USB cable (not Press and hold TIME/DATE for 2 seconds supplied). to select 12 or 24 hour format. Press TIME/DATE to confirm. -
Page 12: Update The Firmware
Adjust brightness • Press repeatedly to select different levels of display light. • Press and hold to turn on or off the bottom light. 3 sec Follow onscreen instructions to complete firmware updating. Note • During the firmware updating, keep the iPod/ iPhone/ iPad powered on and docked on DS1600. -
Page 13: Product Information
5 Product information Note • Product information is subject to change without prior notice. Specifications Amplifier Rated Output Power 2 x 2.5 W RMS Signal to Noise Ratio > 55 dBA MP3 Link Input 650m V RMS Amplifier Speaker Impedance 4 ohm Speaker Driver 1.5''... -
Page 14: Troubleshooting
If you encounter problems when using this device, check the following points before requesting service. If the problem remains unsolved, go to the Web page (www.philips. com/support). When you contact the Consumer Care, make sure that the product is nearby and the model number and serial number are available. - Page 16 This product has been manufactured by, and is sold under the responsibility of Gibson Innovations Ltd., and Gibson Innovations Ltd. is the warrantor in relation to this product. Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V. and are used under license from Koninklijke Philips N.V.