Table of Contents
Advertisement
■ Embroidery Settings
1 Select the embroidery frame to be used.
2 Select the center point marker or grid lines.
3 Select the thread color display on the embroidery
screen; thread number, color name. (page 77)
4 Select the thread brand of the thread color display.
(page 77)
5 Adjust the maximum embroidery speed (page 77).
6 Adjust the upper thread tension for embroidering
(page 74).
7 Select the height of the embroidery foot during
embroidering (page 55).
8 Select the display units for embroidering (mm/inch).
9 Select the color of the background for the embroidery
display area.
0 Select the color of the background for the thumbnail
area.
A Select the size of pattern thumbnails.
B Adjust the distance between the pattern and the basting
stitching. (page 70)
C Adjust the distance between the appliqué pattern and
the outline (page 70).
D Adjust the position and brightness of the embroidery foot
"W" with LED pointer (this setting is available if
embroidery foot "W" with LED pointer has been
attached.) (page 59)
■ Wireless LAN Settings
1
2
3
4
5
6
7
1 Enable/Disable the wireless LAN function (page 20).
2 Shows the connected SSID.
3 Set the machine to connect wireless LAN function.
4 Shows the machine name used on the wireless network.
8
9
5 Change the machine name used on the wireless
0
6 Check the wireless LAN status.
A
7 Display other menus.
B
8 Reset network operations.
C
9 Display the introduction to the application.
D
■ Setting the [Eco Mode] and the [Shutoff
Support Mode]
You can save the machine power by setting the [Eco
Mode] and the [Shutoff Support Mode].
If you leave the machine turned on without using it for the
set period of time, the machine enters in each mode. Press
(page 16)
[Eco Mode];
Machine will enter a sleep mode after the set period of
time. Touch the screen or press the "Start/Stop" button to
continue operating.
[Shutoff Support Mode];
Machine will enter the lower power mode after the set
period of time. Turn the machine off and then back on to
restart operating.
9
This name is used when transferring files from the
machine to the embroidery editing software (PE-DESIGN
11).
network.
to display [Eco Mode] and [Shutoff Support Mode].
Note
• If you turn off the machine while the machine is in
the [Eco Mode] or the [Shutoff Support Mode], wait
for about 5 seconds before turning on the machine
again.
LCD SCREEN
1
1
2
3
4
5
6
7
8
17
Advertisement
Table of Contents
