JVC RC-BZ6 Instructions Manual page 14

Troubleshooting
• If you have a problem with your System, check this list for a possible solution before calling for service.
• If you cannot solve the problem from the hints given here, or the System has been physically damaged, call a qualified person, such as your
dealer, for service.
Symptom
No sound is heard.
Unable to record.
Poor radio reception
The CD skips.
The CD does not play.
Unable to operate the Remote Control.
Operations are disabled.
The cassette door cannot be opened.
Specifications
Amplifier
Output Power 3.6 watts per channel, min. RMS at 3 ohms,
from 150 Hz to 15 kHz, with no more than
10% total harmonic distortion
Output Sensitivity/Impedance (1 kHz)
Phones 16 ohms - 1 kohm
0 - 20 mW/ch output into 32 ohms
Cassette Deck
Frequency Response 80 - 12,500 Hz
Wow and Flutter 0.15% (WRMS)
CD Player
Signal-To-Noise Ratio 90 dB
Wow And Flutter Unmeasurable
Tuner
FM Tuner
Tuning Range 87.5 - 108.0 MHz
AM Tuner
Tuning Range 530 - 1,710 kHz
Antenna Telescopic antenna for FM
Built-in ferrite core antenna for AM
Speakers 10 cm (3-15/16")
12
Possible Cause
• The power cord is disconnected.
• The batteries in the Unit have lost
their charge.
• Headphones are connected.
Cassette record protect tabs are removed.
• The System is not properly posi-
tioned.
• The Antenna is not properly posi-
tioned.
The CD is dirty or scratched.
The CD is upside down.
• The path between the Remote Con-
trol and the sensor on the Unit is
blocked.
• The batteries have lost their charge.
The built-in microprocessor has mal-
functioned due to external electrical
interference.
During tape playing, the power cord was
unplugged.
General
Dimensions
Mass
Accessories
Power Specifications
Power Requirements
Power Consumption
2, 3 ohms
Action
• Connect it firmly
• Replace the batteries.
• Disconnect the headphones.
Cover the holes on the back edge of the
cassette with tape.
• Turn the System to the best reception
position.
• Extend the Antenna and turn it to the
best reception position.
Clean or replace the CD.
Put the CD in with the label side up.
• Remove the obstruction.
• Replace the batteries.
Unplug the Unit then plug it back in.
Plug in the power cord, press the
POWER button, and then press the §
STOP/EJECT button.
438 175.5
(17-1/4
Approx. 4.2 kg (9.3 lbs) (without batteries)
Power Cord (1)
Remote Control (RM-SRCBZ6) (1)
AC 120 V ~ , 60 Hz
18 watts (power on mode)
2.8 watts (in Standby mode)
Design and specifications are subject to change without notice.
261.5 mm (W/H/D)
6-29/32 10-5/16 inches)