Table of Contents
Advertisement
3.4. First use
1. Remove any protective film from the outside
or inside of the appliance, including
accessories.
2. Remove any labels (apart from the rating
plate) from the accessories and from the
oven cavity.
3. Remove and wash all the appliance
accessories (see 4 Cleaning and
Maintenance).
4. Heat the empty oven at maximum
temperature (using traditional functions) so
as to remove any manufacturing residues.
For the first heating use a traditional
function and not a microwave function.
3.5. Using the oven
Opening the door
To open the door press PT1 briefly.
Operating modes
This product is programmed to provide 3 operating
settings, which can be\modified by pressing PT2.
Stand-by: activated as soon as the current time
has been confirmed, with DSP1 on and showing
the current time
02:30
ON: from the standby setting, press PT2 once. All
the displays and knobs light up.
02:30
OFF: from the ON setting, press PT2 once.
Only the symbol
on DSP1 remains on.
16
16 / EN
Use
The
heating
system
immediately in any of these functions, in order
to improve operator safety.
Setting the time
On the first use,or after a power failure
be flashing on the appliance's display. To be able
to start any cooking function, the current time must
be set.
1. Press PT1 for 3 seconds to set the current time.
2. Turn PT1 to the right and left to increase or
decrease the hours.
3. Press it once to move on to setting the minutes.
4. Turn it the right and left to increase or decrease
the hours and press it to set the current time.
5. The symbol
which will stop flashing.
6. Press PT1 again and the minutes will Flash,
turn right left to set the minutes.
7. Press PT and the time is set.
Setting the current time
It might become necessary to change the current
time, for example at the switch from summer to
winter time. To do this, start from the standby
setting (see "Operating modes"). Now repeat the
operations described in point "Setting the time".
It is not possible to change the time if
the oven is ON.
Selecting the function
1. In the ON state only, a cooking function can be
selected by simply turning PT2 to the right or
left.
2. The function selected will change colour to
orange on DSP3.
3. The preset cooking time will be displayed on
DSP1 and the preset parameters (temperature,
microwaves power, weight) are displayed in
alternation on DSP2.
is
not
activated
will appear on the display,
will
Advertisement
Table of Contents
