Pnp/Pci Configuration - Acer Aspire T310 Service Manual

PnP/PCI Configuration

The following table describes the parameters found in this menu. Settings in boldface are the default and
suggested settings.
Parameter
Reset Configuration Data
Resources Controlled By
IRQ Resources
PCI/VGA Palette Snoop
NOTE: It is strongly recommended that only experienced users should make any changes to the default
settings.
Chapter 2
Description
Selecting "Enabled" to reset Extended System
Configuration Data (ESCD) only if you installed
a new add-on and the system reconfiguration
has caused such a serious conflict that the
operating system can not boot. Otherwise, you
should leave it unchanged.
This BIOS can automatically configure all of the
boot and Plug and Play compatible devices.
You can also set it as Manual and go into each
of the sub menu to choose specific resources.
The items are adjustable only when "Resources
Controlled By" is set to Manual. By pressing
"Enter" to access the sub menu.
Disabled - Data read or written by the CPU is
only directed to the PCI VGA device's palette
registers.
Enabled - Data read or written by the CPU is
directed to both the PCI VGA device's palette
registers and the ISA VGA device's palette
registers, permitting the palette registers of both
VGA devices to be identical.
Options
Disabled
Enabled
Auto (ESCD)
Manual
PCI Device
Reserved
Disabled
Enabled
*If any ISA bus adapter in the
system requires VGA Palette
snooping, the setting must be set
to "Enabled".
35