Setting The Humidity Level; Water Level; Refilling Water - Philips HU4802/01 User Manual

Setting the humidity level

Note
•
Make sure that the water tank is filled with
water before the humidifier can function (see
the chapter 'Getting started', section 'Prepare
for humidification').
•
The humidifier will turn on at intervals, in order
to ventilate air around humidity sensor, therefore
get more accurate reading on environment
humidity. This setting applies to the humidity
level setting, including the Auto mode.
1
Press the humidity button
more times to set the desired air humidity
to 40RH%, 50RH% or 60RH% (fig. m).
» The humidity light (40, 50 or 60) of the
humidity level goes on.
» The humidity indicator light is red if the
desired humidity level is not reached.
The light turns blue when the desired
humidity level is reached.
Tip
•
A comfortable humidity level is from 40RH% to
60RH%. You can choose the preferred humidity
level at 40%RH, 50%RH or 60%RH..
Note
•
If no preset humidity level is selected, the
humidity indication light will be off.

Water level

When there is not enough water in the water
tank, the appliance will work in the following
ways.
•
•
The appliance will resume work when you refill
water into the water tank.
once or
•
If the water tank is empty when the humidifier is
plugged in and switched on, the red
light blinks for 2 minutes and then remains on
before the water tank is refilled with water.
•
It is normal to find some water left in the tank.
Refilling water
Water level can be observed through the
transparent water tank window.
1
2
3
•
When filling water, do not exceed the maximum
water level, or water might leak from the drain
hole and air inlets.
•
Do not shake the water tank when moving it,
or water might leak from the drain hole and air
inlets.
•
Do not fill water through the air outlets on top
of the humidifier.
4
The water level drops and the red
indicator light starts blinking (fig. h).
The humidifier continues to work for
30 minutes and then stops working, the
red indicator light remains on.
Note
Switch off the humidifier and unplug it.
Remove the upper unit by holding it at
both sides (fig. b).
Fill the water tank with cold tap water
until water reaches the maximum water
indication level (fig. f).
Note
Place the upper unit back onto the water
tank.
indicator
EN 7