Advertisement
(b)
The wire which is coloured blue must be connected to the terminal which is
marked with the letter N or is coloured black.
(c)
The wire which is coloured brown must be connected to the terminal which is
marked with the letter L or is coloured red.
FITTING THE SNEEZE SCREEN
The sneeze screen is removed from the unit prior to dispatch to eliminate breakage
during transit. Please see the following procedure:
(a)
Push the glass up behind the top glass
support (1).
(b)
Hinge the glass behind the lower glass
support (2).
(c)
Slide the glass into the lower glass
support (3).
(d)
The glass may be removed for cleaning
by reversing the above process.
3.
USE AND BEST PERFORMANCE
The Heated Display Unit is operated by the right hand rocker switch on the rear of the
appliance. The gantry is operated by the left hand rocker switch on the rear of the
appliance. To obtain the best performance, the following procedure is suggested:
(a)
Turn the unit on at the mains.
(b)
Pre-heat the Heated Display empty for 30 minutes prior to use, by operating the
right hand rocker switch.
(c)
Switch the gantry on 5 minutes prior to use, by operating the left hand rocker
switch.
(d)
Load the Heated Display Unit as required.
It is recommended that all containers used on a Glass Top are flat bottomed, to obtain
maximum heat transfer from the Glass Top to the container.
Containers should be lifted onto the Glass Top and lifted off the Glass Top, as sliding
containers across the glass can result in scratching and gouging of the glass. Containers
should not be dropped onto the glass as this can result in breakage of the glass.
Please remember a Heated Display Unit is not designed to heat up or cook food, but is
designed to maintain it at a satisfactory temperature before serving.
2
Advertisement
