Table of Contents
Advertisement
Setting the Temperature Control
•
The cabinet temperature is controlled by the thermostat located at the back of the unit.
Rotate the dial to adjust the cabinet temperature.
•
To turn the freezer off, turn the temperature control to 0.
•
Turning the temperature control clockwise from this setting turns the device on
automatically.
•
The settings 1 through 5 regulate the inside temperature. Setting 1 (minimum) results
in the warmest inside temperature, while setting 5 (maximum) results in the coldest
inside temperature.
•
During initial operation, turn the temperature control to the highest setting (5) first, and
leave it there for about 20 minutes. Afterwards, turn the control back to the medium
position of 3. This setting should be correct for most uses.
•
The optimum position of the temperature control depends on the temperature you
prefer. Cabinet temperature is affected by the ambient temperature, frequency of door
opening, the amount of stored items and the placement of the freezer. You should
adjust the control according to current conditions.
•
Although the temperature control is generally set at the midpoint of the dial, when room
temperature is lower than usual, you should place the dial at a lower setting. Conversely,
if room temperature is higher than normal, adjust the thermostat to a higher setting.
NOTES:
Turning the temperature control to the 0 position stops the cooling cycle but does not
shut off the power to the unit.
If the unit is unplugged, has lost power, or was turned off; you must wait 3 to 5 minutes
before restarting the unit. If you attempt to restart before this time delay, the unit will
not start.
Using the Freezer
•
This compartment is designed for the long term storage of frozen items.
•
Recommended storage times should not be exceeded. Instructions regarding the care
of frozen items should be followed when defrosting the freezer.
•
Place frozen items into the freezer as quickly as possible. If there are instructions on the
packet, carefully follow these instructions regarding storage times.
Defrosting Your Unit
When? For the most efficient operation and minimum energy consumption, defrost the unit
when the frost on the evaporator wall is excessive or ¼ inch thick.
How? Remove all frozen items from the unit and place in another freezer. To start
defrosting, turn the temperature control to 0, unplug the unit and remove the frozen items
and shelf. After the frost or ice has melted, use a clean sponge or towel to remove the
melt water, then thoroughly dry the interior of the unit. The unit can be restarted by
turning the thermostat to the desired setting.
CAUTION
Although you can place a bowl of warm water (about 125°F) into the freezer to
speed defrosting, do not use boiling water because it could damage plastic parts.
In addition, never use a sharp or metallic instrument to remove frost as it may
damage the cooling system and will void the warranty. We recommend using a
plastic scraper.
OPERATION
5
Advertisement
Table of Contents
