Table of Contents
Advertisement
CS-A9DKA CU-A9DKA / CS-A12DKA CU-A12DKA /
10.5.5. CONNECT THE CABLE TO THE
INDOOR UNIT
1. The inside and outside connecting cable can be connected
without removing the front grille.
2. Connecting cable between indoor unit and outdoor unit
shall be approved polychloroprene sheathed 3 (C7DK,
C9DK, C12DK, RS-C7DK, RS-C9DK, RS-C12DK) or 5
(A7DK, A9DK, A12DK) × 1.5 mm
designation 245 IEC 57 or heavier cord.
• Ensure the color of wires of outdoor unit and the
terminal Nos. are the same to the indoor's respectively.
• Earth lead wire shall be longer than the other lead wires
as shown in the figure for the electrical safety in case of
the slipping out of the cord from the anchorage.
• Secure the cable onto the control board with the holder
(clamper).
1. Open the front panel.
2. Remove the air filters.
3. Remove Supersonic air purifying device.
2
flexible cord, type
Please follow the steps below to take out front grille if
necessary such as when servicing.
1. Open the intake grille and remove the screw at the front of
2. Set the vertical airflow direction louver to the horizontal
48
INSTALLATION OF SUPER ALLERU-BUSTER FILTER
Open the Supersonic air purifying device frame.
Insert the super alleru-buster filter and close the Supersonic
air purifying device frame as shown in illustration at right.
HOW TO TAKE OUT FRONT GRILLE
the front grille.
position.
Advertisement
Table of Contents
