LG TM-1830C2L Svc Manual page 48

5. When Vertical Louver does not operate.
• Confirm that the Vertical Louver is normally geared with the shaft of
Stepping Motor.
• If the regular torque is detected when rotating the Vertical Louver with
hands
• Check the connecting condition of CN-U/D Connector
• Check the soldering condition(on PWB) of CN-U/D Connector
• Confirm that there is DC + 12V between pin
GND.
• Confirm the assembly conditions that are catching and interfering parts
in the rotation radial of the Vertical Louver
Copyright ©2008 LG Electronics. Inc. All right reserved.
Only for training and service purposes
Normal
Check the operating circuit of the Vertical Louver
If there are no problems after above checks
- 48 -
(RED) of CN-U/D and
LGE Internal Use Only