Whirlpool CFCR70111 User Manual And Warranty page 11

User manual
Fabric type / Symbol on the wash label
• Cottons, mixed fibres, easy care/synthetics, wool, handwash
items.
• Colour
Separate coloured and white items. Wash new coloured
articles separately.
• Size
Wash items of different sizes in the same wash load, to
improve washing efficiency and distribution of the articles
in the drum.
• Delicates
Wash delicate items separately; they require gentle
treatment.
Change temperature, if needed
•
Press the "Temperature"button to progressively
lower the temperature setting until cold wash
has been set ("- -" will be shown on the display).
Pressing the button again sets the highest possible
setting.
Change spin speed, if needed
Press the "Spin Speed" button to progressively
•
decrease the spin speed until the spin cycle is
turned off ("0" will be shown on the display).
Pressing the button again sets the highest
possible setting.
Select options, if needed
Press the button to select the option; the respective
•
symbol on display illuminates.
•
Press the button again to cancel the option; the light
extinguishes.
! If the selected option is incompatible with the programme
set, the incompatibility will be signalled by a buzzer (3
beeps) and the corresponding indicator light will flash
! If the selected option is incompatible with another
previously set option, only the most recent selection will
remain active .
5. Add detergent
Pull out the detergent dispenser and add detergent
(and additives/softener) into the relative compartments
as described in section "DETERGENT DISPENSER".
Observe the dosing recommendations on the
detergent pack.
Correct dosing of detergent / additives is important, because:
• it optimizes the cleaning result.
• it avoids irritating residues of surplus detergent in your
laundry.
• it saves money by avoiding waste of surplus detergent
• it protects the washing machine by avoiding calcification
of components.
• it respects the environment by avoiding unnecessary
environmental burden.
6. Delaying the start of a programme
• To set a programme to start at a later time, see the section
"OPTIONS/ START DELAY".
7. Start programme
• Press the "Start/Pause"
illuminates, the door locks and the "Door locked"
indicator lights up.
• To avoid overflow, do not open the detergent dispenser
during a running programme anymore.
• The remaining programme duration can vary. Factors
like unbalance in the wash load, or foam formation, can
have an effect on the programme duration.
8. Change the settings of a running programme, if
needed
You can still change the settings while a programme is
running. The changes will be applied, provided the
respective programme phase has not finished yet.
To change the settings of a running programme:
• Press "Start/Pause"
on pause.
• Change your settings.
• Press "Start/Pause" again to continue the
programme.
If you have changed the programme, do not add detergent
for the new programme.
To prevent that a running programme is changed by accident
(for instance by children), use the "Key lock"
"FUNCTIONS").
Pause a running programme and open the door, if
needed
• Press " Start/Pause" to pause a running programme.
• Provided water level or temperature is not too high, the
"Door locked" indicator light turns off. You can open the
door, for example to add more laundry, or to remove
laundry which was loaded by mistake.
• Press " Start/Pause" to proceed with the programme.
9. Cancelling a running programme, if needed
• Press and hold the "ON/OFF"
washing machine stops.
• If the water level and temperature are low enough, the
door unlocks and may be opened.
• The door remains locked if there is water in the drum.
To unlock the door, switch the washing machine on,
select the "Spin & Drain" programme and turn the spin
option off by setting the spin speed to "0".
• The water is emptied and the door unlocks at the end of
the programme.
10. Switch off the washing machine after programme
End
• At the end of the cycle, the message "END" is shown on
the display.
• The door can only be opened when the symbol "Door
locked" light turns off.
• Check that the "Door locked"
then open the door and take out the laundry.
• Press "ON/OFF" to switch the washing machine off.
To save energy, if the washing machine is not switched
off manually with the button, it turns off automatically
approximately 30 minutes after the end of the programme.
Leave the door ajar to let the interior of the washing machine
to dry.
. The relative indicator lamp
to put the running programme
(see section
button until the
indicator is off,
EN
11