Door; Accessories; How To Use The Appliance; First Time Use - Whirlpool CFCR70111 User Manual And Warranty

Table of Contents

Advertisement

User manual

DOOR

To open the door, pull the handle.

ACCESSORIES

Contact our After-Sales Service to check if the following accessories are available for your washing machine (and dryer) model
STACKING KIT SHELF
By which your dryer can be fixed on top of your washing
machine to save space and to facilitate loading and
unloading your dryer in the higher position.

HOW TO USE THE APPLIANCE

FIRST TIME USE

Remove any manufacturing debris:
• Select the " Cotton" programme at a temperature of 60°C.
• Pour a small quantity of detergent powder into the main
wash compartment
of the detergent dispenser(maximum
1/3 of the quantity the detergent manufacturer recommends
for lightly soiled laundry).

DAILY USE

PREPARING THE LAUNDRY
Empty pockets
• Coins, paper clips, etc. could damage the load and
the washing machine components.
• Tissues will break down during the wash cycle,
and the fragments will have to be subsequently
removed by hand.
Close all zippers, buttons, and hooks. Tie all
ribbons or belts
• Insert the smaller garments (e.g. nylon hosiery,
belts, etc.) and garments with hooks into a fabric
bag or a pillowcase with a zipper. Remove any
rings from curtains, or else place the curtains
inside a fabric bag together with the rings.
HOW TO USE THE WASHING MACHINE
1. Load laundry
Open the door and load the laundry. Load the
articles one at a time loosely into the drum,
without overfilling. Observe the load sizes given
in the "PROGRAMME CHART" table. Overloading
the machine will result in unsatisfactory washing
results and creased laundry.
10
To close the door, hold the handle and
push so that you can hear it click shut.
• Start the programme without adding any laundry.
• See section "DAILY USE" for more information on how to
select and start a programme.
2. Close door
Make sure that no laundry gets stuck
between door glass and rubber seal. Close
the door so that you can hear it click shut.
3. Open water tap
Make sure that the washing machine is connected
to the water mains. Open the water tap.
Switch on washing machine
Press the "ON/OFF"
, the "Start/Pause"
slowly.
4. Set the desired programme
Select the required programme with the "Programme
selector" dial. The duration of the wash cycle is shown
on the display. The washing machine automatically
displays the maximum temperature and spin speed
settings possible for the selected programme. Adjust
the temperature and/or spin speed settings if needed
with the relative buttons.
lamp flashe

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents