Raymarine HYPERVISION HV-300 Installation Instructions Manual page 29

3. Adjust the band saw's fence to be the distance specified in the
width of your cutting guide, if used.
Using the fence to blade table measurements ensures that the cut will be made at an appropriate
place on the fairing, producing 2 equally sized parts.
4. Position the block against the fence so that the top face of the block is closest to the fence.
Important:
When installed the pointed end of the fairing must point towards the bow. Ensure that the fairing
is orientated correctly on the band saw table so that the correct angle is cut for the side you are
installing. When cutting the port side fairing the pointed end of the fairing should be pointing away
from you, when cutting the starboard side fairing the pointed end should be pointing towards you.
5. Ensure that the cut will be made within the acceptable cutting area of the fairing.
Important:
Only cut in the shaded area. Do NOT cut in the hatched areas.
6. Recheck steps 1 to 5.
7. Cut the block.
Installation
fence to blade table added to the
29