Panasonic CW-C53HU Service Manual page 14

3. INSTALL THE AIR CONDITIONER IN THE WINDOW
a. Carefully lift the air conditioner and slide it into the
open window. Make sure the bottom guide of the air
conditioner drops into the notches of the
L bracket. See Fig. 28.
IMPORTANT :
When the air conditioner drops into the L bracket, the air
conditioner will be centered in window opening as shown in
Fig. 29.
b. While steadying the air conditioner, carefully bring the
window sash down behind the upper guide of the air
conditioner, as shown in Fig. 30.
4. SECURE THE GUIDE PANELS
Extend the guide panels (TYPE F) to fill the window
opening using 4 screws (TYPE B) to secure them, as
shown in Fig. 31.
5. INSTALL THE SASH SEAL AND SASH LOCK
a. Cut the sash seal (TYPE E) to the window width. Stuff
the sash seal between the glass and the window to
prevent air and insects from getting into the room, as
shown in Fig. 31.
b. Fasten the L bracket using a screw (TYPE A), as
shown in Fig. 31.
6. a. Remove the screws that secure the cabinet and base
pan in the right side.
b. Fasten the suport bracket (TYPE G) using a removed
screw. Attach the suport bracket (TYPE G) in the inner
window sill with a screw (TYPE B), as shown Fig. 32.
7. Window installation of room air conditioner is now
completed. See ELECTRICAL DATA for attaching
power cord to electrical outlet.
3.2.4 How to Secure the Drain pipe
In humid weather, excess water may cause the BASE
PAN to overflow. To drain the water, remove the DRAIN
CAP and secure the DRAIN PIPE to the rear hole of the
BASE PAN. (Fig. 33) Press the drain pipe into the hole
by pushing down and away from the fins to avoid injury.
INNER SILL
OUTER SILL
SHORT SIDE
OUTSIDE
Figure 28
L BRACKET
Figure 29
WINDOW FRAME
UPPER GUIDE
BOTTOM
GUIDE
Figure 30
L BRACKET
TYPE A
TYPE B
Figure 31
Figure 32
Figure 33
DRAIN PIPE
—14—
TYPE A
INSIDE
CENTER LINE
8"
8"
CENTER LINE
SEAL
ABOUT 6.35mm(1/4")
L BRACKET
SASH SEAL
(TYPE E)
TYPE B
Support Bracket (TYPE G)
hang push
DRAIN CAP