Panasonic CW-C53HU Service Manual page 13

Installation
HARDWARE
TYPE A: 11EA
(SHORT SCREW)
10mm(2/5")
TYPE D: 1EA
(SEAL STRIP)
(Adhesive backed)
3.2.2 BEFORE INSTALLATION
1. Insert the guide panels into the guides of the air condition-
er. Fasten the curtains to the unit with screws (TYPE A),
as shown Fig. 25.
2. Cut the adhesive-backed seal strip (TYPE D) to the win-
dow width.
Remove the backing from the seal strip and attach the
seal strip to the underside of the bottom window. (Fig. 26)
3.2.3 NOW START INSTALLATION
1. LOCATING UNIT IN A WINDOW
Open the window and mark center line on the center of
the inner sill, as shown in Fig. 27.
L
2. ATTACH BRACKET
a. Install the L brackets behind the inner window sill, with
the short side of bracket as shown.
Use the 2 screws (TYPE A) provided.
b. The bracket helps to hold unit securely in place. Be
sure to place bracket edge flush against back of inner
sill. See Fig. 27.
CAUTION
During the following step, hold unit firmly until
window sash is lowered to top channel behind
side panel frames. Personal injury or property
damage may result if unit falls from window.
TYPE B: 4EA
(WOOD SCREW)
16mm(5/8")
TYPE E: 1EA
(SASH SEAL)
(Not adhesive backed)
Figure 25
Figure 26
Figure 27
—13—
TYPE C: 3EA
(L BACKET)
TYPE F: 2EA
(GUIDE PANEL)
TYPE A
SEAL STRIP
(TYPE D)
INNER SILL
DRAIN PIPE
TYPE G: 1EA
(SUPPORT BRACKET)
TYPE A