Maintenance; Motor Brushes; Optional Accessories - DeWalt D25430 Manual

EN G LIS H
2. Select the direction of rotation.
3. Insert the special SDS Plus
adaptor for use with hexagonal screwdriver bits.
4. Insert the appropriate screwdriver bit. When
driving slotted head screws always use bits with
a finder sleeve.
5. Gently press the variable speed switch (a) to
prevent damage to the screw head. In reverse
(LH) rotation the tool speed is automatically
reduced for easy screw removal.
6. When the screw is flush with the workpiece,
release the variable speed switch to prevent
the screw head from penetrating into the
workpiece.
Chipping and Chiselling (fig. 1, 3)
1. Set the mode selector switch (d) to the
hammering only position. Refer to Selecting
the Operating Mode in Assembly and
Adjustments.
2. Insert the appropriate chisel and rotate it by
hand to lock it into one of 12 positions.
3. Adjust the side handle (f) as required.
4. Switch on the tool and start working.
5. Always switch off the tool when work is finished
and before unplugging.
WARNING:
• Do not use this tool to mix or pump
easily combustible or explosive fluids
(benzine, alcohol, etc.).
• Do not mix or stir flammable liquids
labelled accordingly.

MAINTENANCE

Your D WALT power tool has been designed to
e
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
WARNING: To reduce the risk of
injury, turn unit off and disconnect
machine from power source before
installing and removing accessories,
before adjusting or changing
set-ups or when making repairs.
Be sure the trigger switch is in the OFF
position. An accidental start-up can
cause injury.
10

Motor Brushes

screwdriving
®
D
automatically stops the drill when the brushes wear
out. This prevents serious damage to the motor.
New brush assemblies are available at authorised
D
replacement parts.
Lubrication
Your power tool requires no additional lubrication.
Cleaning

Optional Accessories

Various types of SDS Plus
available as an option.
Consult your dealer for further information on the
appropriate accessories.
WALT uses an advanced brush system which
e
WALT service centers. Always use identical
e
WARNING: Blow dirt and dust out of
the main housing with dry air as often as
dirt is seen collecting in and around the
air vents. Wear approved eye protection
and approved dust mask when
performing this procedure.
WARNING: Never use solvents or
other harsh chemicals for cleaning the
non-metallic parts of the tool. These
chemicals may weaken the materials
used in these parts. Use a cloth
dampened only with water and mild
soap. Never let any liquid get inside the
tool; never immerse any part of the tool
into a liquid.
WARNING: Since accessories, other
than those offered by D
not been tested with this product, use
of such accessories with this tool could
be hazardous. To reduce the risk of
injury, only D WALT recommended
e
accessories should be used with this
product.
®
WALT, have
e
drill bits and chisels are