Brother 888-F52 Operation Manual page 34

Upper Threading
d Insert the horizontal spool pin onto the bobbin winder
shaft.
Insert the horizontal spool pin so that it is perpendicular
to the bobbin winder shaft.
1
1 Bobbin winder shaft
e Swing the spool pin toward the left so that it is
horizontal.
f Place the upper thread spool for the needle on the right
side onto the horizontal spool pin, and then secure it
with the spool cap.
The thread should unroll from the top front of the spool.
1
1 Spool cap
2 Spool
Thread the upper thread in the same way that the
g
upper thread for the left side was threaded.
1
1 Thread guide cover
• For details, refer to steps
"Threading the upper thread" on page B-21.
B-26
2
g i
through of
h Without passing the thread through the needle bar
thread guide, manually thread the right needle.
Insert the thread through the eye of the needle from the
front.
• The needle threader cannot be used with the twin
needle. If the needle threader is used with the twin
needle, the machine may be damaged.
i Attach zigzag foot "J".
• For details on changing the presser foot, refer to
"Replacing the presser foot" on page B-31.
CAUTION
• When using the twin needle, be sure to attach
zigzag foot "J". If bunched stitches occur, use
presser foot "N" or attach stabilizer material.
j Turn on the machine and select a stitch.
• For stitch selection see "Selecting a stitch pattern" on
page B-34.
• See "Stitch Setting Chart" on page B-46 for stitches
that use a twin needle.
CAUTION
• When using the twin needle, be sure to select
an appropriate stitch, otherwise the needle
may break or the machine may be damaged.
k Select (Twin needle) in the settings screen.
l Set the twin needle mode to "ON."
m Press .
CAUTION
• When using the twin needle, be sure to select
the twin needle setting, otherwise the needle
may break or the machine may be damaged.