How To Use - Panasonic ER-SB40-K Operating Instructions Manual

3
Disconnect the adaptor after charging is completed�
While charging
The charge status lamp ( )
glows.
The battery capacity lamp will
blink in order of "LOW", "MID",
and "HIGH" while the charging
progresses.
Notes
• If there is noise from the radio or other sources while using or charging
the appliance, move to a different location to use the appliance.
• The battery will deteriorate if not used for over 6 months, so
make sure to perform a full charge at least once every 6 months.
• The charging time may differ when using the appliance for the
first time, or if it has not been used for more than 6 months. The
lamp on the appliance may not glow for several minutes when
first starting charging, but will glow when continuing to charge.
• Recommended ambient temperature for charging is
10 °C – 35 °C (50 °F – 95 °F). It may take longer to charge, or
the charge status lamp ( ) will blink quickly and the battery may
fail to charge properly in extremely high or low temperatures.
• When the charge status lamp (
second), there is a charging malfunction. Please charge the
battery in the recommended ambient temperature range.
• 1 full charge will provide approximately 60 minutes of continuous
operation. (Based on dry using at 20 °C – 30 °C (68 °F – 86 °F))
The operating time may differ depending on the frequency of use
and the operating method.
10
After charging is completed
The battery capacity lamp and
the charge status lamp ( )
will light up and then turn off
after 5 seconds.
) is blinking rapidly (twice every
• The battery used is a lithium‑ion, so charging after every use will
have no effect on battery life.
• If the shape of the plug does not fit the power outlet, use an
attachment plug adaptor of the proper configuration.

How to use

• Turn the appliance off.
• Apply the oil to the blade before and after each use.
(See page 14.)
• The appliance may not operate in an ambient temperature lower
than approximately 5 °C (41 °F).
• Do not use with shaving foam applied or when the beard is wet.
A wet beard may stick to the skin or bunch up, making it difficult
to trim.
• Before trimming, comb your moustache with a comb.
1
Mount the desired attachment and adjust the
trimming height as needed�
2
Press and trim�
• The power cannot be turned on when the
switch lock lamp ( ) blinks, as the power
switch is locked.
Press the power switch for more than
2 seconds to unlock. (See page 11.)
Using the trimming height comb attachment
Using without the attachment
(See page 12.)
(See page 12.)