Advertisement
Install brackets.
Firmly press the toilet gasket onto the
toilet outlet of plastic trap.
NOTE 1:
Wax ring type toilet gasket
should not be installed at temperatures
o
less than 21 C.
NOTE 2:
If you are using a toilet
gasket with an integral plastic sleeve,
make sure the gasket is positioned
with the sleeve facing away from the
toilet.
Install plastic to ground and mounted
with 3 set of bolts (not supplied) firmly.
NOTE: Must use the toilet installation
gasket ring (not supplied) to seal the
area where the waste pipe contacts
the construction section to avoid
leakage.
Carefully align and lower the bowl.
Apply weight to the bowl rim to let the
outlet insert into plastic trap.
Carefully thread the screws into the
brackets, until toilet is secure.
Alternately tighten left and right sides
to prevent pulling the toilet off center.
Install cap to cover screw.
Do not overtighten.
1364890-T01-B
Fig.#6
6
Plastic Trap Outlet
Fig.#7
7
Fig.#8
8
Outlet
Plastic Trap
Fig.#9
9
Bushing
Screw
Fig.#10
Cap
-5-
Toilet Gasket
1
2
)
10
o
21
C
3
)
(
(
Advertisement
