Table of Contents
Advertisement
Basic Operation
1. Turn On the TV and Your DVD Player
Press the Power button on the player or the remote controller, and "Read" appears on the
TV screen. If there hasn't a disc in the DVD player, "No disc" will be displayed on the screen
2. Place A Disc
Press the Open / Close button on the remote controller or the front of the DVD player, and
"Open" appears on the screen. Then Place a disc gently into the tray with the disc's label
facing up (double-sided discs have content on both sides, so you can place either side up),
and press the Open / Close button again to close the disc tray, "Close" appears and the player
starts to read. Then the disc starts playing automatically. (Note: Of some certain type discs,
after reading out the type, the Play or Enter button should be pressed to start playing.)
3. Play
The contents of each disc menu vary according to how the disc was authored and what
features are included. The disc menu will be turned on for you to select, when Root button
pressed. Also play and pause can be switched with the Pause button on the remote. Moreover,
such as menu play, title play, sequence play etc., these different play modes are offered.
a) Menu Play (compatible with DVD, VCD2.0 discs)
I.
Press Root Button
!
TV screen displays the DVD Root Menu when a DVD disc is loaded.
!
When a VCD 2.0 disc is loaded, VCD 2.0 menu will be displayed on the screen
(when PBC is off) (At this moment, press PBC button once to display current
PBC state).
!
PBC is initialized on when a VCD2.0 disc is loaded.
II.
When a DVD disc is loaded, you can press Arrow buttons to highlight the menu
item you want to choose; As VCD2.0, you can press Numeric buttons to select a
track to play.
III. Press Enter or Play button, you can begin play with the highlighted.
IV. Return when playing: When a DVD disc is playing, press Root button, and you can
return to Root Menu; As VCD2.0, and PBC is on, press PBC button, you can return
to the menu.
V. Stop
1)
When you press Stop button for the first time, the player turns into quasi stop
state. At the same time the OSD appears "Quasi Stop". To begin the title over,
press Stop twice.
2)
In quasi stop state, the player remembers where you stopped, when you start
playing the disc again, the DVD player picked up where you left off.
3)
In stop state, when you press Play, the player enters sequence playback mode.
!
For the disc protection, before you press Open / Close button to eject the disc
tray when playing, please press Stop button at first. After taking out the disc,
press Open / Close again to close the tray.
!
If you're not going to use the DVD player for a long time, be sure to remove
the electronic plug.
6
Basic Operation
Advertisement
Table of Contents
