Mounting The Cable Cover - NEC PA803UL User Manual

Mounting the cable cover

Mounting the cable cover on the projector allows you hide the cables for a tidy appearance.
CAUTION
• After mounting the cable cover, be sure to fasten using the screws provided. If not, the cable cover could fall
and damage the cable cover and possibly resulting in injury.
• Do not bundle the power cord and place it under the cable cover. Doing so could lead to fire.
• Do not hold the cable cover while moving the projector and do not apply excessive force to the cable cover.
Doing so could damage the cable cover, resulting in the projector falling or causing injury.
Mounting
Preparations:
1. Connect the power cord and cables to the projector (the connection cords are omitted from the diagrams).
2. Prepare a Phillips screwdriver.
1. Insert the two round protrusions on the left and right edges
of the cable cover into the grooves in the bottom of the
projector to line it up.
NOTE: Be careful not to let the power cord and cables get pinched by the
cable cover.
2. Turn the cable cover screw clockwise.
• Tighten the screw securely.
Removing
1. Turn the cable cover screw counterclockwise until it turns
loosely.
• Hold the cable cover while doing this to prevent it from
falling.
• The screw does not come completely off.
2. Remove the cable cover.
• Turn the cable cover a little, then lift it off.
7
1. Introduction
1
2
2
1